NT16 Revert to stock issues

---

hey guys,
i have a 1.43 nt16 rooted and running cm10 from internal. i forgot to run a backup prior to installing. i cannot find a 1.43 rooted, or stock rom anywhere. i found a 1.40, and a 1.42, however after these flash, it gets to the setup, but the touch screen is non responsive. therefore i cannot go any further. any advice? anyone have a stock, or stock rooted 1.43 i can download to get this puppy back to stock?

Originally Posted by haloseven

hey guys,
i have a 1.43 nt16 rooted and running cm10 from internal. i forgot to run a backup prior to installing. i cannot find a 1.43 rooted, or stock rom anywhere. i found a 1.40, and a 1.42, however after these flash, it gets to the setup, but the touch screen is non responsive. therefore i cannot go any further. any advice? anyone have a stock, or stock rooted 1.43 i can download to get this puppy back to stock?

Could this work? http://forum.xda-developers.com/show....php?t=1663836

I just did the unbrick method and although it completed the unbrick successfully, when it rebooted, the touchscreen still doesnt work. im just going to chalk it up to a faulty refurb. im perplexed though, as CM10 works fine, if i put it back on there.

I would run cm10 from sdcard and flash back factory touch firmware

Sent from my Barnes & Noble Nook Tablet using my fingers to Swype

Did you try to hold power + N to reset your nook 8 time? It will go back to stock rom

Sent from my Barnes & Noble Nook Tablet using xda premium

Originally Posted by BadKid3011

Did you try to hold power + N to reset your nook 8 time? It will go back to stock rom

Sent from my Barnes & Noble Nook Tablet using xda premium

The ROM isn't the problem. The op needs to reflash the 2 touch firmware.

Sent from my CM 10 SD nook tablet. Thanks devs.

i just took it into a BN store and they swapped me for another refurb. thanks for the help though!