Within this Odin One Click are the Kepler_odin_new_part_JE3_S1JE4.pit, param.lfs, smaller cache.rfs, smaller dbdata.rfs, and larger dbdata.rfs files ---- all from the i897uckf1 leaked firmware. (Because these files have not been included in any of the i897 leaked firmwares from kh3 up to kk4)
Go to Post #3 in this thread and use the Odin or Heimdall to get the latest Stock KK4.
Use the one with Bootloaders, unless u already know u have the i897 GB Bootloaders.
Sent by XDA Premium App
Go to Post #3 in this thread and use the Odin or Heimdall to get the latest Stock KK4.
Use the one with Bootloaders, unless u already know u have the i897 GB Bootloaders.
Sent by XDA Premium App
See the "Connection Issues..." Sticky Thread in the General Forum.
It did not flash. U need to read that stickied thread and try again.
Sent by XDA Premium App
My phone was flashed to Serendity rom, and it got a lot of bugs, so I failed to flash back to latest stock KK4.
<OSM> All threads completed. (succeed 0 / failed 0)
<ID:0/003> Added!!
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Set PIT file..
<ID:0/003> DO NOT TURN OFF TARGET!!
It stayed this screen like a couple hours, then I unplugged the usb cable, and my phone got stuck in recovery mode. I can only go to downloading mod, but I can't do anything as Odin didn't connect it.
Any advice?
Just tried it, but Odin fail.This happened to me too. Thought I was screwed but when I put phone into dload mode, Odin still recognized the phone (yellow com port showed up on Odin) as long as that shows up, Odin should still work. Did for me at least. Should be able to get back to stock from there.
you are evolutionary success, act like it
DOWNLOAD INSTRUCTIONS:
-Perform a factory reset on your phone. (Optional, recommended)
-Download any OneClickOdin package to your desktop.
-Be sure you have the Captivate drivers installed on your computer.
-Right click and Run as admistrator the Odin.
-Remove your sim card and external sdcard from you phone.
-Put your phone into download mode. (Press and hold both volume buttons and insert USB cable into phone)
-Wait for Odin to recognize your device. Yellow com port will light up.
-Click the big Start Button.
-Sit back and watch. This should only take between 2 or 3 minutes to complete.
-When the process is finished and your phone begins to reboot and you see the at&t screen you may go ahead and unplug the micro usb from your phone.
TIP:
Once you're on AT&T GB Bootloaders, I would advice you to use bootloader free package always in future. So far AT&T GB bootloaders have been backward compatible with all I897 (even I9000) Froyo/Eclairs ROMs. I have used I9000 based ROMs with AT&T GB BLs. Someone in CM7 thread claimed to use AT&T GB bootloaders with CM7 without any problem.
PS: More than half of the modems listed here, I have collected from here and there, don't even remember from where. However I remember there was one website where I found most of them. Rest are simply packed by me using same zip script from others. I am just putting up all Stock Captivate stuff at one place.
EDIT: Found the original thread by Oxicottin. Most the modems here are done by him. Check out his website for location wise data for best modems. Check this thread for a get around on RAT selection restrictions on i897 modems.
Also, check this thread for more I9000 based modems and modem dance. (I9000 modems requires I9000 based ROM and reoriented kernels.)