Oh, you're in the wrong forum my friend. You have the One X+ right?
Sent from my Evita.
There is no best radio for anyone. Signal strength and battery performance are dependant on geographical location and other factors. You need to test a few and find which one works best for you. Don't rely on the bars in your status bar though, check the actual strength in Settings/About Phone.
Sent from my Evita.
You're not bound to only the at&t radios, you can try any of them. You just install a radio in recovery like you would a ROM or kernel.
Sent from my Evita.
Yes, you flash it just like you would flash a full ROM. It is an OTA though, not a full ROM, so you must have the previous version already installed. For example, if you want to flash the 4.1 OTA, you must already have 4.0 installed. If you have no version of Viper already installed you can't flash an OTA, you must flash the full ROM.
Sent from my Evita.
I already have the 4.0 version flashed and working properly and that to your help previously, i had updated the firmware and hboot.
Thanks timmaaa
---------- Post added at 03:01 PM ---------- Previous post was at 02:49 PM ----------
By the way, should i wipe the data same as installing a new rom, or just install the OTA Update of Viper ROM.
I know these are all noob questions, but i bricked my phone already, that is why i am asking all these questions.....
Thanks
my hboot version was 2.10, my phone is s-off and supercid; so i wanted to upgrade its hboot to 2.14; I used some simple commands from fastboot; but it stopped at the 70 or 80 percent; without any progress; so i used command: "fastboot reboot-bootloader". but after that my phone doesn't turn on. even not charging. what shall i do?
Your phone is the middle eastern variant of the Evita. It's been theorised that the hboots from the standard Evita might not be compatible with the middle eastern Evita, and unfortunately I think you've proven that right. I think you've bricked your phone.
You could try leaving it connected to a wall charger overnight (at least eight hours) and trying to power it on again. If that doesn't work you'll need to get a jtag repair done.
Sent from my Evita.
I have a very quick questions.
Will the modified TWRP version that, in my understanding, is made to flash KitKat ROMs also flash Sense 5 ROMs?
Many thanks!!
I have question for you, while I'm sitting here waiting out the RUU process...
Once the RUU has run, and hopefully successfully updated my firmware, does it delete everything on my phone?
I know I have to reflash my recovery at that point, but will I still have root, and will my currently loaded ROM still be installed or do I need to install a new ROM right after I install my recovery?
Also, does the RUU process delete the contents of my SD card?
Sent from my Nook Tablet using Tapatalk
---------- Post added at 03:02 AM ---------- Previous post was at 02:04 AM ----------
Well I found out that it doesn't,
I just finished updating the RUU and I am now on Bootloader 3.18/Hboot 2.14 w/S-off. It feels good.
I just installed my first KitKat ROM, and of course the wifi is broken on the latest (Beanstalk) so I just installed the previous version, so now I'm up and running.
Thanks to everyone who assisted in getting me back up to speed with flashing ROMS, etc... Especially Timmaaa! I've learned so much in the last 2-3 days just trying to get this device back up to speed.