Problem with the Corvus5 ROM

---

I was about to post this on Corvus5 dev thread but XDA won't let me

Anyways, I'm experiencing a lag problem when my Advent Vega timesout. This is fresh install of Corvus5 ROM, overclocked to 1.4ghz using SetCPU. After the screen timesout thenr waking the tablet up, everything slows to a crawl. After checking with SetCPU, it seems that I'm stuck at 216mhz.

I have successfully reproduced this bug a few times now, and I have to restart the tablet to make it usable again.

Just an idea but does setcpu have a profile that when you put the device in sleep/idle it clocksdown the cpu to save battery?

No, I don't have any profiles set.

I tried clearing data & cache, reflashing Corvus5, then installing SetCPU only (using corvus' SetCPU Custom config). I can still recreate the bug

Blue led inside POV Mobii

---

I also can't post in the dev thread and experience a "problem" with Corvus5.

Resuming the device, a blue led inside the device will turn on. The led is near the camera under the black border, it leaks a bit of light onto the display (not noticable when the display is on).
Firing up the camera and backing out of it will turn off the led. Suspending the machine and resuming it will turn it on again.

It's more an aesthetic problem, though it may be an extra drain of power.

I'm having this same problem, but I have not been using setcpu

You might want to try another refresh and trying CPU Master to set the Mhz


As for the Blue light for me it is normally when my using is in nvflash mode. Try a hard power off to see if it goes away e.g. hold power for 5 seconds.

If still not gone then once fully powered off put it into nvflash mode and out again.

To do this press back for 1 sec then still holding back press power for 1 sec, then let go of power, wait another second and let go of back. Hence seq is lig
back 1sec
back + power 1 sec
back 1 sec
Let go of buttons

You should now be in nvflash mode, at this stage press power for 5 seconds to get out of it.