[EP1Q] Leaks (Links posted)
From P3 link to Droid world
"This is an even newer build of Gingerbread for the Droid Charge.
A small number of phones experience streaming audio cut-out when a headphone or jack is plugged into the headset jack.
Release notes: This is unofficial and a leak. Teamblackhat, Mydroidworld, and myself are not responsible for what you do to your phone. Installing this firmware will void your warranty and may cause harm to your device.
If you for some reason need to downgrade your firmware you will need to use the file from below to put your phone on an older firmware version. After you have put your phone on the below firmware version you will need to take several OTA updates to get back to the current firmware version."
This are the EP1Q Leaks,I have just downloaded have not flashed please refer to the thread EP1Q Issues
, because there are issues with it. Remember to handle with care. Boot-loop abound…or worse
description: This Odin image has factory radios and kernel. The system has been modified.
P3 special EP1Q
description: This Odin image has factory radios and kernel. The system has been modified to fit TBH debloated specifications. TBH then added in Gtalk w/video, GoLauncherEX, the new Market, and more.
If you like it Donate to TBH
Other stuff you may need:
An idea of what you may have to do…
Originally Posted by JKChad
Files you'll need:
Factory ep1q (non special)
Factory pit file
Step 1: open odin, i use version 1.82. Plug up your phone with battery out and put it in download mode. Now odin should detect your phone. reinsert your battery, may not be needed, but I like to be safe. Now in the options area, this is under the id:com area, uncheck auto reboot and check re-partition. Now click on the tab with pit and select the correct pit file for the charge. This can be found in the droid charge development area. once that's selected you need to select the correct odin image. Click on PDA and find where you've downloaded the stock ED1 image and select it. Again, all of these files can be found in the dev section. Now click start and wait for odin to complete the flashing process. takes approximately 4-7mins.
Step 2 and 3: reset odin and disconnect your phone and reconnect your phone in download mode. For steps 2 and 3. all you'll need to do is uncheck auto reboot and select the correct image file( ep1h for step 2 and then ep1q for step 3). If you wanna be extra cautious, re-insert your battery before you click start. Also, I don't typical flash images through odin with my 4g sim card installed. No idea if it really matters, but I've "heard" of issues and don't want to chance it.
Once you've made it this far. unplug your phone and pull the battery and re-insert it. power up your phone and wait for the sammy logo. You should see the phone wipe a couple of files and then reboot to the samsung logo again. Then you should see the boot animation.
Disclaimer: I'm not responsible if your bork your phone up. Just tryin to lend a hand. Please please make sure you're comfortable with flashing odin and whatnot. This can and will make your phone a $650 paper weight if you're not careful. Hope this helps.
Have fun and I can’t wait to try Humble 2.3
, Danalo said something about butter right? I like Butter.