FORUMS

Digitiser Buttons Plastic Prongs

20 posts
Thanks Meter: 1
 
By CraiGDaniel, Junior Member on 25th February 2012, 03:45 PM
Post Reply Subscribe to Thread Email Thread
When replacing the digitizer i read somewhere i need to transfer the old plastic prongs to the new digitizer, the ones under the 3 buttons at the bottom of the digitizer.

Does anyone know exactly how these are place? Because it doesn't seem to fit properly when i try to attach the LCD to the digitizer, the little prongs raise the Digitizer off the lcd.
 
 
Post Reply Subscribe to Thread

Guest Quick Reply (no urls or BBcode)
Message:
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes