Originally Posted by Deceptitech

I had downloaded all of the components, and loaded the SD card, but when I run the Rhodium.nbh file from the bootloader, when it restarts I get nothing but a black screen. Currently using a Rhod 100 model.

Also, how can you tell of your ADB works before doing this procedure?

I know I am not stupid, having modified several phones and flashed many ROMs(currently running energy on this one, with the SD card running Froyo B1.), I just have a touch of ignorance.(yes, there is a difference)

Any assistance would be greatly appreciated.
Thank you.

Well, ADB and linux commands used in Android development will be a new challenge for you. Normally setting up ADB and the correct drivers for your phone are not too difficult. You might have some problems though since the TP2 doesn't actually have any android drivers made for it by HTC. You are welcome to try and teach yourself and get your computer set up. It might take some tinkering if you have never done it, but it can be done. Here are a couple of threads that should give you enough information to start. Good luck!

http://forum.xda-developers.com/showthread.php?t=879701

http://forum.xda-developers.com/show....php?t=1421760

Thank you.

I may be old, but always willing to learn. And the best way to learn is experimentation. Only one more question I have before I continue on is simple. With the nbh file, it is supposed to load some text on screen, and not be black, correct? If it is, that is where I have hit a dead end. I got ADB and Fastboot to work, and I do have drivers that will work with the phone.

Thanks.

Originally Posted by Deceptitech

Thank you.

I may be old, but always willing to learn. And the best way to learn is experimentation. Only one more question I have before I continue on is simple. With the nbh file, it is supposed to load some text on screen, and not be black, correct? If it is, that is where I have hit a dead end. I got ADB and Fastboot to work, and I do have drivers that will work with the phone.

Thanks.

The NBH is flashed like any WinMo ROM. Place NBH at root of SD. Name RHODIMG.NBH. Put phone in bootloader mode, should see NBH and flash as usual.

Originally Posted by Deceptitech

Thank you.

I may be old, but always willing to learn. And the best way to learn is experimentation. Only one more question I have before I continue on is simple. With the nbh file, it is supposed to load some text on screen, and not be black, correct? If it is, that is where I have hit a dead end. I got ADB and Fastboot to work, and I do have drivers that will work with the phone.

Thanks.

yeah, when following instructions from first post, at the point where you boot to bootloader while plugged into usb, the phone will ask if you want to flash (the screen might be grey, can't remember).

Make sure file is named correctly and also try dl nbh again. might be bad dl

edit: arrrghhh beat me to it. lol

Wifi problems are fixed with 3.3.6 kernel. Will upload later a new build. (GSM)

Originally Posted by walter79

Wifi problems are fixed with 3.3.6 kernel. Will upload later a new build. (GSM)

New build is online. (GSM only can`t test on cdma)

Is BT working with this build?

Originally Posted by motisu

Is BT working with this build?

On/off works. did not test more. I will check if my headset works.

Originally Posted by walter79

Wifi problems are fixed with 3.3.6 kernel. Will upload later a new build. (GSM)

tetering not working? i can't start it - jast Error.
and this kernel is too slow? i think so

Hi great build ! it is working great on my rhodium100_de

but i have to problems :

- need german keyboard file
- ts.calibration seems of