How to do JuoPunutbear easily (My own personal experience)
Well, this thread is going to be based on telling you how I completed Juopunutbear since I have no wires around already, I had to be creative and it worked out really well.
Things you'll need:
Downloaded Juopunutbear - Can be fetched from http://Unlimited.io
Ethernet cable
Doubleshot
Knife or scissors
Step 1:
Take ethernet cable and cut the wire open. You will see a couple of wires. Cut both ends to be an appropriate length (I cut about 3 inches of length to use)
Step 2:
Take stripped ethernet cable and pull out one of the wires.
Step 3: Strip about a half inch off the end of each side of the wire so you get the hard copper to show up.
Step 4: Twist the ends so that they are size appropriate for the contact point and can maintain better contact in general.
Step 5: Run control bear and follow instructions with retwisting the copper if you need to according to seperation. If you know what you're doing, it should be done in a few minutes :P
Step 6 - Optional : Recover your SD card for use again Can be found in post 2
*Note: I take no credit for Juopunutbear, only where my name is referenced in credits on unlimited.io Nothing else.
Credits to Team Unlimited and their respective members.

Attention all: deck is a scrub.
My Google Plus account
My Twitter
Shiftless evo shift developer
Nook Tablet developer-found root (here)
Quote:
|
Without developers this place would not be called XDA-Developers but something else, e.g Mobile Phone User Support Services For Ungrateful Nerds.
|
Developed on the following devices: Evo View, Nook Tablet, Evo Shift, Nexus S 4G (private), Evo 4G (private), Mytouch 4g Slide, Evo LTE (In progress)
|