Hi.
ADD. MTsol reported he(she) flashed PRL with QPST without problem so you can use QPST if you have one.
Here's my second thread about PRL writing for our Optimus G with LGNPST.
I'm not sure if I can share the LGNPST here or not so just pm me if you need it.
Let's get started.
1. Make sure your phone is Diag mode enabled. (you can find out how to from the link above.)
2. Open LGNPST.
3. Connect your OG to your PC as Charge Only mode.
4. You will see this screen, click PRL/ERI tab then check Write, NAM1, NAM2.
5. Load the PRL file you want to use. (You can find PRLs from here http://xdaforums.com/showthread.php?t=1880781
or google it and you can find PRLs easily.
6. Press start.
7. It will ask your SPC.
8. Just wait... Your OG will reboot by itself.
9. Done. :good:
P.S. If LGNPST pops up an error MSG, just reboot your OG once then press ok button.
P.S.S. Dang.. picture size is too big... I'm gonna make them smaller later....
ADD. MTsol reported he(she) flashed PRL with QPST without problem so you can use QPST if you have one.
Here's my second thread about PRL writing for our Optimus G with LGNPST.
I'm not sure if I can share the LGNPST here or not so just pm me if you need it.
You don't need root access for this but you MUST HAVE your OG's SPC.
Follow this http://xdaforums.com/showthread.php?t=2032431 thread and get SPC first.
You can always go back to original PRL by Updating PRL from your OG.
`System Settings -> System Updates -> Update PRL'
Let's get started.
1. Make sure your phone is Diag mode enabled. (you can find out how to from the link above.)
2. Open LGNPST.
3. Connect your OG to your PC as Charge Only mode.
4. You will see this screen, click PRL/ERI tab then check Write, NAM1, NAM2.
5. Load the PRL file you want to use. (You can find PRLs from here http://xdaforums.com/showthread.php?t=1880781
or google it and you can find PRLs easily.
6. Press start.
7. It will ask your SPC.
8. Just wait... Your OG will reboot by itself.
9. Done. :good:
P.S. If LGNPST pops up an error MSG, just reboot your OG once then press ok button.
Last edited: