FORUMS

[FTF] Sony Xperia Z Lollipop Release

Sony rolled out a Lollipop update for Xperia Z just yesterday. If you still haven’t gotten … more

Original Moto G Receives Lollipop, OTA Captured

The original Moto G was released almost two years ago. Motorola still continues to … more

Device Review: No.1 X1 Rugged Smartphone

We are almost at the end of Q2 for 2015, and we have seen most of the flagship phones for the … more

When a Friend or Family Member Asks for a Phone Recommendation, What Do You Tell Them?

The majority of us here at XDA would consider … more
Post Reply Subscribe to Thread Email Thread

delivering an application

30th April 2003, 03:33 PM |#1  
OP Junior Member
Thanks Meter: 1
 
More
Hi,

I want to deliver application on SD/MMC-Cards.

I have build a well-working cab-file with cabwiz.

The problem is, that the cab-file is deleted after executing.

Question:
Knows anyone how to achieve, that the cab-file is N O T deleted?

Question:
How can I execute the cab-file from a simple setup-program (which then saves the cab-file)?

Franz
The Following User Says Thank You to xgadkob For This Useful Post: [ View ]
 
 
30th April 2003, 05:16 PM |#2  
Junior Member
Thanks Meter: 0
 
More
Just make the file read-only and it won't be deleted after installation.
30th April 2003, 08:55 PM |#3  
OP Junior Member
Thanks Meter: 1
 
More
Sounds very nice,

but my MDA-Pocket PC has only a SoftInputPanel.

I can't find the ALT-Key and don't know how to get a property-panel.

Perhaps you can help?
30th April 2003, 08:57 PM |#4  
Junior Member
Thanks Meter: 0
 
More
If you use another file explorer like resco explorer, you can get to the properties by holding down the stylus on the file then choosing properties.
1st May 2003, 10:26 AM |#5  
Member
Thanks Meter: 0
 
More
Set the File to Read Only on your PC before copying it to the SD/MMC-Card
30th November 2009, 10:09 PM |#6  
Noonski's Avatar
Moderator Emeritus / Recognized Developer
Flag Amsterdam
Thanks Meter: 125
 
Donate to Me
More
Wow this is an old and unanswered thread.

The registry entry
HKCR\cabfile\Shell\open\command = 'wceload.exe "%1" /nodelete

On the device controls what is the default command to execute a .cab file so the above will leave it be.

Or you could try to add
HKLM\Software\apps\Microsoft Application Installer\nDynamicDelete = 0 (DWORD decimal)
To the cab and hope that this registry entry gets picked up immediately after installation.

Setting read only is the best user friendly way though, as you don't change default behaviour in the device.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes