I had some spare time today so I decided to write a script for you all (I know how redundant it is, but hey why not)
This script incorporates the core functionality of adb into it, such as detecting your device... that's pretty much it at this stage..
I doubt this will brick anyone's devices... but just in case..
if this bricks your device, it was not my fault. you used this at your own risk.
I don't care if this crashes your computers, or shoots you in the foot. you used it, not me
firstly, you have to choose your command from this list
secondly: the length of that command (in hexadecimal) needs to be prefixed before the command is sent. This is probably to do with security so the adb server on the device only reads the right amount of data
thirdly:... well there's not much more to it. just enjoy, tinker with it, and remember to contribute!!
note about getting device detected:
You need to ensure that the Android Debugging Bridge driver is installed for your device. this is normally supplied with standard device drivers. please refer to your device forums for instructions on how to install these
You also need to make sure your pc is authorised with stock adb, otherwise you won't be able to connect with PyAdb (for 4.2 upwards)
note about the current shell integration:
I now have a threaded interactive console, however single commands are still not read from a thread. If you want to use grep or kmsg, launch a full session