S-Pen dock sensor bounce problem (Fixed)
Hi. Sorry for my English.
I had problem on my SM-605 with S-Pen dock. On an every tablet vibration, the tablet said that the pen is out (while it is in).
I opened the tablet and noted that the T-shaped rotary button that is responsible for S-Pen In or Out is very short, so, when S-Pen is in, it is between On and Off, so every vibration swithes it.
I fixed it:
I took some Gel glue (is is called 'Moment' / "Момент" in Russia) and put some at the end of the T-shaped button. It was hardening for 24 hours (with tablet's back opened and camera module covered to protect from dust). Then I've assembled all back. Now I have to put S-Pen out for 2mm to make sensor switched.
Some photos (sorry, newbies unable to post pictures or links)
The problem: Stilus is in, but the buton is not pressed. It's original shape of the button, it is a little bit bended to right (or possibly it is bad button and originally it is planned to be straight?)
https:??www dropbox com?s?gbrpv1isup3vwa8?2014-01-21%2000.31.50.jpg
The glue gel is fresh, not hardened yet
https:??www dropbox com?s?u0eg6uqqfpgpwju?2014-01-21%2001.15.01.jpg
https:??www dropbox com?s?ywruv84wtf582k0?2014-01-21%2001.15.22.jpg
PS> BTW, back cover is GLUED to the case. Click-locks are deep, about 2cm from the edge. So open carefully. The cover can be bended quiet well without breaking it.
PPS> Alternatively, you can glue some tape at the end of the S-Pen (on the round part of it), but be careful not to detach the tape and leave it inside while putting S-Pen in\out.