I have just replaced the lcd and digitizer for my Nexus 7. The repair was about as easy as expected. I put everything back together and all the ribbon cables are seated as they should be. My issue is that it will not power up or stay on when I fit the back cover on.
I can power on the device with the case half way on it powers up and the touchscreen is fine. I fit the back cover back on and it's like it shorts outs. The screen goes black.
I have pulled it apart again and have checked and rechecked all my cables and reseated the battery. Both boards are seated. The symptoms tell me it should be a poorly seated cable but they are seated just as I found them.
Has anyone else run into something like this or have any other ideas on what it might be?
Sent from my SM-N900A using XDA Free mobile app
I can power on the device with the case half way on it powers up and the touchscreen is fine. I fit the back cover back on and it's like it shorts outs. The screen goes black.
I have pulled it apart again and have checked and rechecked all my cables and reseated the battery. Both boards are seated. The symptoms tell me it should be a poorly seated cable but they are seated just as I found them.
Has anyone else run into something like this or have any other ideas on what it might be?
Sent from my SM-N900A using XDA Free mobile app