Attend XDA's Second Annual Developer Conference, XDA:DevCon 2014!
5,731,698 Members 49,574 Now Online
XDA Developers Android and Mobile Development Forum

Again new ROM, just released!!

Tip us?
 
jsp_m
Old
#1  
jsp_m's Avatar
Senior Member - OP
Thanks Meter 1
Posts: 299
Join Date: Aug 2006
Location: Zagreb
Default Again new ROM, just released!!

V1.32.251.1 RUU: v3.13.0.0

Radio: v1.27.00.10
OS: AKU2.3 (14955)
IPL/SPL: 1.00/1.07.0000
Language: ENG (UK), ENG (US), Finnish, Swedish, Norwegian, Danish, German, Italian, French, Spainish, Portuguese, Dutch, Greek.



Changes:

1 Phase in Streaming Player.
2 Phase in HSDPA icon.
3 Fix to ITS #1778 When enabling FDN, only 4 digits can be entered in the PIN2 box. PIN2 should allow up to 8 digits .
4 Fix to Voda sim voice mail missing notification issue. Double check solution is in codebase.
5 Set prefer data call to 3G
6 Fix Radio become "no signal" issue
7 Low volume of alert ting tone when breeze is waken up by an incomming call.
8 Fix Wmodem would be stoped with Win2K OS.
9 Fix cold boot lock up issue.
10 Fix "found display turn off in one minute while playing a WMV file."
11 Fix: Some the reset radio will fail while there is a command is waiting the response.
12 Fix: The RIL driver will read wrong EF between 2G and 3G SIM.
13 If ATA followed a "No carrier", fake a "OK" as a response and see the "No carrier" as a unsolicitd command.
14 Fix "in voice call, if there comes another incomming call, uplink will be mute."
15 Bluetooth HCI transport driver performance improvement.
16 Remove all customization setting.
17 Update Magneto O.S to AKU3.3 build 15671.
18 [AKU 3.3] Incorrect "E" icon on the top of screen is displayed under 3G service.
19 There is no error message when activating PDP with incorrect APN, and system will become strange after that.

RADIO NEWS:

1 PS data stopped after VT call.
2 Fine tune BT quality by changing audio parameter.
1. support AT@AMUX=0~3 for MFG
3
2. add Athena DPRAM gpio in AT@GPIO for MFG
4 Protect AMSS.
5 Call Forwarding setting does not work in FET due to redundant "time" included if not "NO REPLY".
6 Remove SMS reply procedure.
7 Don't handle the max length of phone number correctly.
8 CE sent twice +GTKE(menu selection) to radio will cause radio hang.
9 Phonebook will be locked once SIM is PIN1 blocked, and it will never come back until resetting.
10 Send "Done" when rec empty SS_Release_Complete msg .
11 Protocol stack still camps on network when PIN1 is blocked.
12 +CREG may be sent before IMSI attach procedure is completed.
The MO call CCBS no inband tone issue at Sweden 2g/3g network. By disabling the CMSP bit in Classmark 2 and
13
PCP bit in Setup.
14 Return OK and no unsolicited +CREG and +CGREG sent out when manual selection to a forbbiden PLMN.
15 Add debug output to ATDBG when Attach, LAU, and RAU rejected.
16 CHLD=2 has no response when collision with MT disconnection.
17 Add unsolicited +HTCerror to report EF extension full/over boundary condition.
18 There is Incorrect bearer service code of call forwarding, when issue SS string "**21*09011111111*20#".
Fix ORO SIM issue, when user make a MO call, ME perform IMSI detach and then call drop.
19
Unable to receive calls from PABX lines in Australia when calling party subaddress is included in MT setup. This is
20
due to incorrect CLIP format response sent to CE.
When PIN1 is disabled and user forces to issue changing PIN, some SIM card will return incorrect sw1/sw2 and
21
cause wrong UI display.
22 Implement +BANDSET functionality.
GMAC will stock (PS service not possible) when CS_PS registered then LUP failed twice with cause
23
PLMN_NOT_ALLOWED (for instance)
Add AT command at@clearall at@cleargps at@clearhot to manage the GPS data in EFS. Modify AT@setgps let
24
device can do warm and cold start without resetting the device.
25 Implement the Test mode for GPS Cold and Warm start for n times.
If remote call disconnected before STOP DTMF Ack received and modem WON'T response +VTS and reset by
26
WINCE finally.
1. disable USB regulator at default
27
2. let radio USB go to suspend after @USBPOWER=0
28 Add statistcc report for Test mode.
1. Add logs for tracking RTC and Tun
29
2. Preload Almanac data of 20060904
It can't camp on to STARHUB 3G (always seaching signal) while manual sitch to STARHUB 3G band under
30
STARHUB 2G band.
31 When there is a active call, can't make a mo call.
32 Add new +TTYMODE AT command to enable/disable TTY support in radio stack.
33 During SIM Initialization, delay +COTA notification after phonebook cache finish.
When edit the SetNetwork (edit PPLMN), If the user entered PLMN is not in the defult list. It will show "000000" to
34
WINCE. It's saved in SIM correctly but show not correct to user.
35 USSD notification could not be sent to RIL and return USSD Busy to network.
Reset or call failed will happen if network config T314 =0 and T315 !=0 when PS RAB +CS RAB and then radio link
36
failure happened.
37 SMC procedure fails due to simultaneous SMC procedures triggered by Lucent UTRAN.
38 Unable to answer the 2nd incoming call if end the first active call and attempt to answer the 2nd incoming call.
39 It can transmit event for DIAG port to fix Embedded log stall issue.
40 Fix time error of QXDM log.
41 Showing EDGE indicator when Serving cell support EDGE (Enabled for CE after AKU3).
42 Add AT+OSVER for CE to tell radio its version.
43 Fix time error of QXDM log.
44 Drop VT data when PCD=9,0
Phonebook extension support: 1. EF files support (EF EMAILi, EF GRPi, EF GASi, EF IAPi) through AT+PHSM, 2.
45
Support over 1,000 phonebook entries.
 
etienne
Old
#2  
Junior Member
Thanks Meter 0
Posts: 16
Join Date: May 2004
Location: Bordeaux
Ok...
where ? where ? where ?

Etienne
 
Royan
Old
#3  
Senior Member
Thanks Meter 7
Posts: 298
Join Date: Dec 2006
Location: Bergen
Quote:
6 Fix Radio become "no signal" issue
YES!
Maybe this will finally fix the disconnect issues I've been having.

Please, please, please upload it

Royan
 
jsp_m
Old
#4  
jsp_m's Avatar
Senior Member - OP
Thanks Meter 1
Posts: 299
Join Date: Aug 2006
Location: Zagreb
I will upload it within 12 hours, will send link (45 MEGS)
 
smfa1965
Old
#5  
Member
Thanks Meter 1
Posts: 76
Join Date: Dec 2004
Location: Boston, MA
Yes! Please do. Can't wait to test.
 
SecureGSM
Old
#6  
SecureGSM's Avatar
Senior Member
Thanks Meter 1
Posts: 502
Join Date: Sep 2006
Location: Melbourne
hmmm...

in Changes:

".. 17 Update Magneto O.S to AKU3.3 build 15671..."

in ROM info (?):

OS: AKU2.3 (14955)

Is that right?
Himalaya / Typhoon / Wizard/ Tornado / wizard/ Universal / Star Trek / Hermes / Breeze / Oxygen / Excalibur / Trinity / Artemis / HP hw6965 / Herald / Cavalier/ Treo 750 / Vox / Elf / Niki / Polaris / Pharos/ Juno / Wings / Kaiser / Sedna / Diamond / Rafael (soon)
------------------
Securing the future of communication
http://www.securegsm.com
 
etienne
Old
#7  
Junior Member
Thanks Meter 0
Posts: 16
Join Date: May 2004
Location: Bordeaux
Thaaaaanks

i'm installing it

3 % completed

Etienne
 
athenix
Old
#8  
Junior Member
Thanks Meter 0
Posts: 2
Join Date: May 2006
Unhappy Where's the link?

Where is the link please? I went home early from work today hoping to test this new ROM.
 
jsp_m
Old
#9  
jsp_m's Avatar
Senior Member - OP
Thanks Meter 1
Posts: 299
Join Date: Aug 2006
Location: Zagreb
OK, it's up at
/Smartphone/Breeze MTeoR/

enjoy!!!!
 
cioppi
Old
#10  
Junior Member
Thanks Meter 0
Posts: 5
Join Date: Jan 2007
where ? where ?

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


TRENDING IN THEMER...