Originally Posted by QAN
In my nouse I have an WIFI network with WPA and WPA2. When I use encryption, even WEP, te connection is established but after a few seconds of data transfer, there is connection goes dead. I tested an open connection, a WEP 64, 128, WPA en WPA2 connection. All except the open unencrypted connection stop working after a few seconds. The Ameo keeps being connected to the accespoints, but there is no traffic anymore.
Has somebody else had this problem? I will try a hard reset to test it with a clean install.
I have no problem using the WIFI. I'm normally able to see about four if I'm at home. The other access points are my neighbours', some of which are secured while others are'nt. If I connect to any one of them they tend to drop off after a while due to week signals. Even if I use my own within the house, the signal is weak sometimes, in which case, the system automatically goes to UMTS connection which is far far faster in my case (Because my WIFI's bottlenect is from the slow ADSL speed of 512kbs download speed max, and my phone, running at UMTS, has higher speed.
So, check the signal strength and see if this is the cause.
Since my works all the time, may be by showing you my wifi configuation for comparison might help.
I'm using WEP data encription. The network key is entered on start>setting>connection>Wi-Fi. I would see all the hot spots there. After I selected my own WIFI, I select connecting to the internet and press NEXT. In the next screen I chose Open WEP and untick automatic box. I then enter the network key which I obtain from my router administration screen on my PC.
That's it. I hope you have your problem resolved soon