Microsoft Voice Command 1.6 + BT Headset = Doesn't work!

---

Hello,

I have Voice Command 1.6 installed on my phone and when I use my headset to initiate the voice command stuff, I get stuck with the crappy Voice Tag software.

This worked perfectly for my Wizard; I just had to change the voice command button to run MS Voice Command and not the Voice Tag stuff. But... I can't, for the life of me, figure it out on this phone! Anyone have ideas? Thanks in advance!

mine works fine. here are my settings

voice enabled--yes
voice button--record
availability--password protected
announcement routing--bluetooth only

not saying that this is the only way for it to work, just that mine works and these are the settings i am using. try to turn on your headset, but activate the voice dial from the phone first by holding down the voice recorder button for 1-2 seconds. after you use it successfully, try to initiate a call from your bluetooth headset. other than that, i am out of thoughts. good luck

Somebody close this thread because I'm retarded as all hell. Sometimes simply rebooting the phone is the best solution. I made sure your settings matched mine and rebooted. What do you know? It works! ^_^ Thanks, guy!

Does it announce calls? Mine only does it for appointments and high importance email

Originally Posted by ID64

Does it announce calls? Mine only does it for appointments and high importance email

Unfortunately, mine does it for appointments and text messages/email (you can set it to announce all of them or only high-priority ones) as well -- the ringtone plays in the headset but no calls get announced, even though it's configured to do that. I really miss that...

Hello me I seek it in French version
Bonjour moi je le cherche en version francaise