Little Cap covering Car Antenna Connector missing,suggestions?

---

Don't know how it happened, but just looked at the back of my Tytn, and it is missing that little plastic/rubber cap that goes over the Car Angenna Connector (that's what they call it in the manual). Can anyone suggest how I could get/buy a new/used one ? I haven't seen any posts of this type of thing happening to anyone else..not sure why? I now realize that it must be a removeable cap. I am surprised that nobody else, seems to lose theirs. Anyways, any suggestions are appreciated. It certainly shouldn't cost a fortune for such a puny thing!..

see if you can find it here..

good luck.

If all else fails, try the end cap from a Bic Stic ballpoint pen -- the little plastic bit plugging the non-writing end of the pen's barrel. Should be pretty close to the right size.

Thank you for your suggestions

---

Will try your link,, and try your Bic suggestions.

One thing you could also do is use a piece of black electrical tape to cover the antenna hole underneath the battery door. When you put the battery door back on, it will look just as it did before as the tape will be underneath it.

I think I found an almost perfect substitute

---

I went to the Home Depot and bought a package of Self-Adhesive Foam and Vinyl Pads. Different sizes, but the one that I bought had black ones, different sizes. I just had to trim ,make a smaller circle out of any of the black ones, to slightly ,but barely overcover the hole, then I placed back the back cover on top of it. You should make sure that the pad isn't too thick. Mine were fine. I suppose, instead of even taking off the back, you could approach it by keeping the back on, cutting a round piece that would fit snuggly into the hole. Too boot, the sticky part, should more or less adhere to the exposed bits that are in the hole. I prefered the other way, because it adhered to the actual back of the phone,near the hole a lot better. Hopefully I helped those people find a better way, than using bic pens blunt end. I tried that , but not nearly as good as my method.