Hermes Mini USB

---

Can anyone confirm that the alignment of the mini usb on the bottom of the Kaiser is identical to the Hermes?

I see some online accessory shops are adverstising car cradles and desktop cradles from the Hermes for the Kaiser.

It'll be great if I don't have to upgrade all this fruit for once.

With regards

I'd like to have that confirmed too.. I already have a desktop cradle but I don't know if the Kaiser fits in there too... (then I can sell the hermes without the cradle)

Its the same orientation

---

Yup its the same orientation

_________________
|_____microsd_____|
|___________|---/_|

Its something like that

Kaiser fits my Hermes Cradle. The mini-USB connector AND it's spacing is the same as Hermes so it fits the cradle, the back is thinner so there is not the same support as an exact fitting version but it will work until I can find a Kaiser version that charges a spare battery like this one.

Can confirm it fits the TyTN cradle - but as said before it is a little loose. I used to stab at the TyTN with a pen in its cradle just fine but need to hold the Kaiser as it rocks back a bit when you press the screen.

R

Originally Posted by rakh1

Can confirm it fits the TyTN cradle - but as said before it is a little loose. I used to stab at the TyTN with a pen in its cradle just fine but need to hold the Kaiser as it rocks back a bit when you press the screen.

R

Right, since the back is thinner, the majority of support is comming from the USB connector. I'm being super careful with mine until a new cradle comes out, would hate to hurt that connector.

Tape or glue some folded-up paper or cardboard onto the cradle to act as a shim -- that should keep the Kaiser from rocking.