Bluetooth and Microsoft Voice Command

---

I know this has been beat to death in the Hermes forum but I have found a bit of difference with my Kaiser as compared to my Hermes.

I have quite a bit of experience with the TyTN hermes tweaks to get Microsoft Voice Command to work with the Hermes but not only will the Kaiser NOT work without the tweaks - I can't get it to work with the tweaks.

I followed the exact instructions like I always have listed in the Hermes Wiki section titled Utilities and Software Tweaks (including Bluetooth Voice Command installation and the Registry changes). However after the changes I cannot initiate a Bluetooth instruction via the Bluetooth device. If I initiate the call via the handheld it works great as far as stability and sound quality.

Any suggestions?

You don't have to do any tweaks on Kaiser! Just install VC 1.6. Assign Button 6 to Voice command. Soft reset. It should work. Works for me at least. The only think that doesn't work is a caller name announcement.

Originally Posted by ID64

You don't have to do any tweaks on Kaiser! Just install VC 1.6. Assign Button 6 to Voice command. Soft reset. It should work. Works for me at least. The only think that doesn't work is a caller name announcement.

Ditto,
My Kaiser does announce incoming callers on the internal speaker when the setting is on "use bluetooth if available". I only use bluetooth with my car so I do not know what the behavior with a headset would be.

Does it work so that you can push the button on your Bluetooth headset or Bluetooth car adapter and then give the Voice Command through the headset? Mine didn't work. That's why I did the tweaks.

Also can someone tell me that with just the Voice Command installed what does the following registry key have (or does it even exist)?:
HKLM\SOFTWARE\OEM\VoiceCommand\Path = ????

AND

HKLM\SOFTWARE\Microsoft\Bluetooth\AudioGateway\BTA GExtModule = ???


Also if you go to settings and click on Voice Command - what version Voice Command do you have? I have v1.6.4622.0

Thanks

GenesysLV,

Can you please check build number of your VC 1.6?


Thanks.

Originally Posted by ID64

Can you please check build number of your VC 1.6?

Not terribly related, but v1.60.4622.0 is what my copy reports as well - though I'm still on a Hermes. I believe that's the retail release, I've not seen any indication of another one....

Richard

Originally Posted by ID64

GenesysLV,

Can you please check build number of your VC 1.6?


Thanks.

I have the same version number. Is there a different place to actually check the "build" ?

Originally Posted by jcrompton

I have the same version number. Is there a different place to actually check the "build" ?

If you go to VC settings, please go to about or something like that. There you will see full version number.

Thanks

yep
its the 1.6.4622.0 version

Originally Posted by jcrompton

yep
its the 1.6.4622.0 version

Thanks Just to confirm: you can hear callers name over your BT car handsfree?