BB Connect version .100 works with touch pro AT&T

---

I have it installed and getting all my work email. I used the BB desktop software to activate although "over the air" seemed as it it would have worked fine because my admin hadn't set up my activation password and my activation attem told me that After installation my BB security was also enforced with device locking.

So grab version .100 and get your email folks

Originally Posted by mallman

I have it installed and getting all my work email. I used the BB desktop software to activate although "over the air" seemed as it it would have worked fine because my admin hadn't set up my activation password and my activation attem told me that After installation my BB security was also enforced with device locking.

So grab version .100 and get your email folks

Did you have to set your aku key to 0.4.2? This is what you had to do on the Kaiser.

I am trying it on the Fuze with no success so far.

Thanks

Juju

Where did you get this version from?

Originally Posted by Ragin Cajun

Where did you get this version from?

You can get it here:

http://www.sems.org/entry.asp?ENTRY_ID=276

I tried version 103 with no success. It does nto seem to connect n order to initialize the service.

Trying version 100 now.

I have a Fuze with Romeo ROM...

I will elt you knwo if it works.

Juju

Originally Posted by mallman

So grab version .100 and get your email folks

Any chance you or someone else can report success in setting up Blackberry ont he Fuze. I installed version 100. I have a Fuze with Romeo 1.40 version.

I can install the cab, go through the reboot, but when I try to activate, it says "The service is no connected. Enterprise Activation will be pending until connected".

Any clues?

Thanks

Juju

I'm using and have been using BB connect version 1.03 with my Fuze since the 10th of Nov. with the Stock rom and now NATF's AT&T bloatfree rom and is running beautifully without having to change AKU or anything else.

I would say from my past experience, it might take a while for initial pin to receive from the BB server, but after that everything works. However this didn't happen to me with Fuze but with my old Wizard when I was all new to the BB connect.

Originally Posted by KarmaNP

I'm using and have been using BB connect version 1.03 with my Fuze since the 10th of Nov. with the Stock rom and now NATF's AT&T bloatfree rom and is running beautifully without having to change AKU or anything else.

I would say from my past experience, it might take a while for initial pin to receive from the BB server, but after that everything works. However this didn't happen to me with Fuze but with my old Wizard when I was all new to the BB connect.

THis is VERY encouraging!
Are you using an Enterprise Server or Internet Server(BES or BIS)?
Let me try NATF's ROM then, I am on the ROMEO ROM now.

Juju