i dont think ive killed my phone. im using it noe to reply. lol. i have not flashed any roms and im attempting. but i own fuze now

when you go into bootloader does it say? 1.90oilnex? i know someone said it before but i just want to make sure you have Hard Spl on there properly.

yes it did before i reflashed hardspl again. and it says it now too.....im sooo lost on what to do

Originally Posted by cediesaid

im not a newby to flashing ive been through my tytn flashing left and right. i just got my fuze about a month ago and ive been reading evaluating all these roms to see which one would be best for me with the least amount of bugs.

i had no issue unlockin my fuze and by doing that i know i can go straight to flashing. but when i go to flash my fuze it gives me a Error Code 244 Device ID....i have no clue and am completely lost. any help?

What ROM (OS or radio; custom or stock) and what version are you trying to flash to?

Originally Posted by cediesaid

i dont think ive killed my phone. im using it noe to reply. lol. i have not flashed any roms and im attempting. but i own fuze now

Originally Posted by cediesaid

yes it did before i reflashed hardspl again. and it says it now too.....im sooo lost on what to do

Ok, now I'm really confused. In the first post, you say the phone is fine and you're using it to write the post. Maybe you're joking there-honestly, I don't know. But if it's fine, then why are you lost on what to do? Is the phone bricked, or is it fine? You can get into bootloader (I assume so, since you know that hard spl was flashed)? Then just flash your previous ROM back onto the phone off of an sd card.

im confused because i keep gwtting the same error message when i go to flash the rom

Originally Posted by cediesaid

im confused because i keep gwtting the same error message when i go to flash the rom

Let's head back to the basics again.
What exactly and completely does it say when you go to the bootloader screen?

What is the model number of the device you are trying to flash?

What carrier do you have?

What ROM are you trying to flash?

What method are you using to flash this ROM?

My bootloader shows the following

Security Unlocked
RAPH110
SPL-1.90.Olinex
MicroP-Raph (LED) v13
MicroP-Raph (KEY) v5
PSOC-Raph STAGE_CVT v0x36

I bought my fuze form a corpoate att store.
I have tmobile and have been using my fuze on the tmobile network for about a month now.

I have tried flashing via usb with actie sync. and when it goes to flash it brings up the percentage bar saying it could take ten minutes and just go straight to 100 percent in like 2 seconds then gives me the error invalid device id.

the rom i was attempting was natv v4 for the fuze. then i tried the elite rom as well. no luck same result

received response

Just flash from your SD card assuming you have one.