Component/Digital cables for "TV out"?

---

Are there retail component cables available for TV out on an HTC device? If there aren't, is there a work around/DIY solution?VGA/S-Video/possibly HDMI....ANY ideas/ contributions are appreciated!

Seems to me it is a software issue and a cable one. The device can only put out NTSC/PAL. Composite video only requires one wire. Component would need 3. Where would the extra pins come from (in the USB connector)?

Wouldnt higher quality S-video still be possible though?

Not sure if this will work for you guys, but I used the multi-adapter that came with my Touch Pro2 and a 3.5mm jack to composite cable to get TV out from my TP2. Basically, it was a cable that came with my camcorder. I had to remove/cut the blue wire inside the multi-adapter to get it to work. It works automatically without additional software. I found the information from another poster at PPCGeeks.com. I would have provided a link, but since I'm a noob, this site would not allow me. Good luck. Hope this information helps.

Originally Posted by Mossesman

Not sure if this will work for you guys, but I used the multi-adapter that came with my Touch Pro2 and a 3.5mm jack to composite cable to get TV out from my TP2. Basically, it was a cable that came with my camcorder. I had to remove/cut the blue wire inside the multi-adapter to get it to work. It works automatically without additional software. I found the information from another poster at PPCGeeks.com. I would have provided a link, but since I'm a noob, this site would not allow me. Good luck. Hope this information helps.

Thanks for your response and yes this does work as I have been using this solution for about two months now and it's "okay" at best...I am still looking for something that would enable at least a "clean" 480p picture with every pixel cleanly represented without all the noise of the composite cables....

I am planning on getting a tv out cable from the following website as soon as my TP2 arrives (hopefully on tuesday):

http://shop.lab88.co.za/pL88OL-61/HT...ro--Pro-2.aspx

The cable sells for R188.00 approx. $25.00

They are the official importers of HTC devices in my country and their prices are very reasonable.

try sparkfun.com and search for 'extusb'. if you are feeling adventurous like me then go for the cheap one (style 1) otherwise go for the one with the breakout board. either way, its good fun but be prepared for anything. you should have a bit of knowledge on how to solder though. tried it myself and it worked but with all the bare wires hanging out of the video cable it's in a box somewhere in the garage, lol.

sorry about my lack of using the shift key, hehe

boxy

Originally Posted by BASSMANBOB

Thanks for your response and yes this does work as I have been using this solution for about two months now and it's "okay" at best...I am still looking for something that would enable at least a "clean" 480p picture with every pixel cleanly represented without all the noise of the composite cables....

I'm not sure if that is possible since the output of the device is not digital. And even with a USB to composite cable, the data will still be in analog. Good luck with your search and please provide an update if you find anything. Thanks.

Im thinking "S-Video" would be achievable, no? Anyone have thoughts?

If you google for "composite-to-s-video" you get lots of little adapters for under $10, so it can obviously be done, but I doubt the video quality can improve. You also see decoders that cost $150.
If you look at the product description here
http://www.amazon.com/Dayton-SVC2-Ja.../dp/B0002KR7G8
it actually says the quality won't be better than the original composite.
It's a huge sight, but it is a better question to research over here:
http://www.avsforum.com/avs-vb/