SPB Mobile Shell 3.5.3 3D acceleration

---

Bit of an odd problem.
I have 3D acceleration enabled, and the carousel works absolutely spot on, even with the Gsensor! But there is a 3D accelerated message viewer that was active when I had MS3.5.1 installed (with the registry mods and chainfire HD2 graphics driver crack) that isnt active in MS3.5.3. It just has the non accelerated message viewer which looks a little naff. Has anyone else come across this problem? Tried emailing SPB about it, but theyre next to useless.

Thanks in advance

Originally Posted by strike-down

Bit of an odd problem.
I have 3D acceleration enabled, and the carousel works absolutely spot on, even with the Gsensor! But there is a 3D accelerated message viewer that was active when I had MS3.5.1 installed (with the registry mods and chainfire HD2 graphics driver crack) that isnt active in MS3.5.3. It just has the non accelerated message viewer which looks a little naff. Has anyone else come across this problem? Tried emailing SPB about it, but theyre next to useless.

Thanks in advance

Have you tried uninstall SPB and re-install it again? This might help

Tried that, and even gone as far as a hard reset, and made no difference

Hi,

have you tried the Chainfire HD2 2d Driver Patch?
I installed it and it seems the grafic performances increased.

The drive i think can be found somewhere here in the forum.
Sorry about this imprecise information, but i actually don't know where i found the file


msdirektor

Is this what you need?

http://forum.xda-developers.com/showthread.php?t=592663

Works like a charm

If I needed that, then why would the carousel be working perfectly?? I did use that when I used spb ms3.5.1 to get that to render smoothly, but its not needed with spb ms3.5.3.

Thanks for your input this far

Anything 3D, you need that driver, its the only thing that will enable you to get any 3D performance out of this phone

3D performance of my tg01 is fine without the driver patch at the moment. NFS runs fine, the 3D accelerated carousel of ms3.5.3 runs at a decent framerate. Its just the message viewer does not open the openGL accelerated viewer, just the standard non-accelerated viewer

Is there a registry entry that would allow you to enable it?

Been looking through all the registry entries and could not find a single entry that affects only the message viewer. I know its not critical, but its bugging me