How to Set up ADB
I see that a few of you have been asking how to set up ADB.. I hope this helps!
Step 1: Download the Android SDK from http://developer.android.com/sdk/index.html
The Windows file is called android-sdk_r4-windows.zip. Extract the files to your C: drive so that you now have the folder C:\android-sdk-windows
Now open up command prompt and type these codes:
If you've been following this guide you will see your phone's serial number. If you get "device not found" error, you either need to make sure you the drivers were properly installed or make sure you enable USB debugging AFTER you connect the USB cable. Continue on once you get the proper phone serial output.
You shouldn't have to install anything other than the HTC Sync... And the only reason you install HTC Sync is for the drivers.. You dont have to install anything for ADB just put the extracted file on the C:\ drive.... And then whenever you wanna Push or Pull a file with ADB, just put that file in the C:\android-sdk-windows\tools file....