Help me i kill my T01a

---

i try to update my phone by pin method ..but i forget to turn on my phone after i bridge the pin 1 and 3 [very stupid ] Result is now i can't open my phone .when i try to turn on the green light[phone status light ]will on for 10 sec and nothing happen .not even the backlight . i using t-01a .please help me to fix this

sadly for my stupid

sorry for my bad english Hope you will help

Thank You

Message deleted because Don't know about T01A, sorry.

Originally Posted by watquik

i try to update my phone by pin method ..but i forget to turn on my phone after i bridge the pin 1 and 3 [very stupid ] Result is now i can't open my phone .when i try to turn on the green light[phone status light ]will on for 10 sec and nothing happen .not even the backlight . i using t-01a .please help me to fix this

sadly for my stupid

sorry for my bad english Hope you will help

Thank You

Try to put original rom in sd and then do the pin method again.
Don't forget charge full your battery.
I'm not sure if go work with it but just try.

with T01A i thought i read somewhere that you have to bridge pin 1 and 2? i think i read it in 'how to flash a custom rom' on the TG01 ROM development page

just read it and it seems i'm talking aload of rubbish, sorry :/

just flash short 1 and 3 with the official rom.

Originally Posted by gamerr120

with T01A i thought i read somewhere that you have to bridge pin 1 and 2? i think i read it in 'how to flash a custom rom' on the TG01 ROM development page

just read it and it seems i'm talking aload of rubbish, sorry :/

just flash short 1 and 3 with the official rom.

Bridge pin 1 and 2, press power button for 10 seconds.

Originally Posted by cktp

Bridge pin 1 and 2, press power button for 10 seconds.

alraeddy tried but still no luck i got only greenlight


however
thank for all helping

sadly