[Q] Audio input via the 3.5mm 4p jack?

dawnofkardath · 2nd March 2011, 03:32 PM

[Q] Audio input via the 3.5mm 4p jack?

I am wondering if there would be a possibility to get a audiosignal eg. linelevel via the 4p jack connector. As for splitting up the headphone output and the mic input and using the mic in with a shunt resistor to match line level for recording into one of the 4track Apps.

- Is there an acessory existing?
- If not, does anybody know the pinout of the jack plug and the impendance of the mic interface?

Anybody tried this jet?

C4NCER · 8th March 2011, 12:51 AM

I'd say it should be possible, as the headphones that came with my wildfire have a built in mic.

As a guess the tip and 3rd ring (both ends) of the jack would be the pins that should be used.

dawnofkardath · 3rd November 2011, 10:03 AM

It works! Finally...

Last weekend i took same time to solder a solution. I managed to make a small box with a voltage divider (impendance changer) and the small 3P jack cable attached. I have now at the box a Potentiometer, headphone out and a more or less "gainable" mono Line in. I can now record 4 tracks of my Guitar into it. Using JZ2 its bit tricky due to the fact that no clicktrack works jet so i record one of the 3 Tracks with a Click and have 3 left. 2 for a mix and one for the recording and bouncing. Hope a metronome will be integrated in the app soon.