Battery Thermal Sensor Causing Boot Loops

16 posts
Thanks Meter: 0
By ELECTRIC1982, Junior Member on 27th October 2015, 03:35 PM
Post Reply Subscribe to Thread Email Thread
Is possible to confirm the issue I am experiencing is due to thermal sensor? if so. is it possible to change the default threshold using adb or some other method that would not require booting the rom.

When I plug the phone in to charge I get a your device is overheated, charge will resume when cooled down, etc. message.

When I try to boot I receive the custom animation and then flash of the ROM starting up abruptly followed by shutting down.

I ran a dumpstate and found the following:

LGE charging scenario : state 0 -> 3(2-1), temp=79, volt=4326, BTM=1, charger=1, cur_set=1600/-1, chg_cur = 26

I'm not sure but I believe the temp should be closer to 25...

running XDABBEB 3.1.2
Attached Files
File Type: txt dmesg.txt - [Click for QR Code] (151.9 KB, 14 views)
File Type: txt truncated_dumpstate.txt - [Click for QR Code] (359.6 KB, 14 views)
Post Reply Subscribe to Thread

Guest Quick Reply (no urls or BBcode)
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes