FORUMS

[AIO Guide] Realme C2 bootloader unlocking,root,twrp & stock firmware

235 posts
Thanks Meter: 72
 
By siddhrsh, Senior Member on 21st September 2019, 09:44 AM
Post Reply Email Thread
10th February 2020, 08:45 AM |#71  
Senior Member
Thanks Meter: 195
 
More
most likely a usage problem
- power off completely
- open device manager
- connect to usb 2.0 port
- install VCOM preloader drivers
preloader only comes up for a second, you must be quick. if VCOM preloader drivers installed it looks like this
if you managed this step you can proceed with creating scatter, like this
10th February 2020, 03:48 PM |#72  
Junior Member
Thanks Meter: 0
 
More
tell me how to remove the password on the phone, forgot the password. Found a way to flash via PC but flashtool asks for a username and password.
11th February 2020, 09:14 AM |#73  
crownvn's Avatar
Senior Member
Flag Hanoi
Thanks Meter: 49
 
More
Quote:
Originally Posted by aIecxs

most likely a usage problem
- power off completely
- open device manager
- connect to usb 2.0 port
- install VCOM preloader drivers
preloader only comes up for a second, you must be quick. if VCOM preloader drivers installed it looks like this
if you managed this step you can proceed with creating scatter, like this

it is funny,
my devices : Rmx1943 2/16 Gb. CPU : MT6765
My PC : win7 32bit
although I installed driver UBS from https://elandroidefeliz.com/drivers-...l-instalacion/
but I check Ports funtion in Device manger .
there are 2 ports : Preloader USB Vcom( androi) and MediaTek DA USB VCOM port that I install by manual but all of them have yellow triangle with exclamation mark inside. it means incorrect driver. it is a root cause when my device on boot loader I can't active any command.
anyone have issue as same as me . could you please share me correct driver. I also search the internet & tried many nut can't not
11th February 2020, 03:12 PM |#74  
Senior Member
Thanks Meter: 195
 
More
pick up the yellow triangle and assign the driver manually
12th February 2020, 07:38 AM |#75  
crownvn's Avatar
Senior Member
Flag Hanoi
Thanks Meter: 49
 
More
Quote:
Originally Posted by aIecxs

most likely a usage problem
- power off completely
- open device manager
- connect to usb 2.0 port
- install VCOM preloader drivers
preloader only comes up for a second, you must be quick. if VCOM preloader drivers installed it looks like this
if you managed this step you can proceed with creating scatter, like this

Quote:
Originally Posted by aIecxs

pick up the yellow triangle and assign the driver manually

yes, I knew & had done but still appear yellow triangle
Post Reply Subscribe to Thread

Tags
realme-c2

Guest Quick Reply (no urls or BBcode)
Message:
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes