Recent content by 2pezboy

I just tried flashing CM 11 (stable build) after doing a complete wipe and have the same results. When trying to place a call it says "Mobile network not available." I have full bars of LTE, data works fine, and settings appear to be correct (still left at default).

Thanks for the suggestion, Brett! If anyone else recommended this, I would be very hesitant. Are there any tweaks I will need to do once I flash the ATT build? Build prop edits, APN edits, etc? Thanks again.

I do have the Verizon Note 2 and have been using Verizon builds. It's not that the phone isn't lighting up. Calls made to it go straight to voice-mail. It doesn't even ring on their end. When I try to place a call, it never goes through. It's holding the signal now, but never connects to...

Thanks for the advice, goofwear! I wiped and flashed official cm 12.1 and nd7 in recovery and that fixed the issue of continually dropping signal. I still can't make or receive calls, though. Data works fine. I flashed a couple of VRToxin versions and all had same result. (Data is stable and...

I had been using the 02/25 version of VRToxin since it came out with very little issues. A couple of days ago my Vzw Note 2 started dropping cell signal. It may hold it for 30 seconds or so, but then drops. Initiating a call will not go through and drops the signal immediately. I can't receive...

I had been using the 02/25 version since it came out with very little issues. A couple of days ago my Vzw Note 2 started dropping cell signal. It may hold it for 30 seconds or so, but then drops. Initiating a call will not go through and drops the signal immediately. I can't receive calls...

I have never changed my APN settings. I attached screenshots in case it helps.

I haven't had any problems connecting to LTE.

I sent you a PM.

I have been having a hard time getting battery use under control too. I have been using Greenify as well. I can't figure out what's eating it.

Tethering not working on mine yet either (running latest 1/22 build). Other than that and something still killing my battery, I am loving MM on my ancient Note 2!

Thanks, Brett!

WiFi Hotspot still not being seen by other devices on 1/17 build.

I am seeing the same with WiFi tethering seeming to turn on fine, but none of my devices can see it as even available. ---------- Post added at 11:03 PM ---------- Previous post was at 10:57 PM ---------- Just saw an update posted yesterday (1/17). Checking it out now. Thanks, Brett...

Disabling proximity sensor isn't a big deal for me. I am super impressed with this being the first build! Did full wipe of everything (including SD card) and clean install (w/TBO). Biggest issue I am having is inability to paste anywhere and can't copy in some places. Someone in the AT&T thread...