Recent content by joelgrice

Thanks for taking the time on this. I'm using TWRP 2.6.3.0. Sent from my Nexus 7 using Tapatalk

Here's the first few lines from my buildprop : # begin build properties # autogenerated by buildinfo.sh ro.build.id=KOT49H ro.build.display.id=KOT49H test-keys ro.build.version.incremental=eng.stm.20140103.004313 ro.build.version.sdk=19 ro.build.version.codename=REL...

When I try to flash this I still keep getting the message that it is not intended for this device. I have a 2013 Nexus 7 (flo) running the latest version of RastaKat & stock kernel. Any suggestions? Sent from my Nexus 7 using Tapatalk

The factory glue is pretty thick. If you attach the lcd to the digitizer without glue between, there may be a slight gap at the rear of the lcd where it rests on the midframe. I'm not sure if it would cause a problem or not. Maybe you could put a spacer between the rear of the lcd and the...

Not sure about the Styrofoam cutter. How thick is the wire? It needs to be about 0.08-0.12 mm. It needs to be perfectly smooth so as to not scratch the lcd. Also you'll need to get it up to 80 degrees Celsius and keep it there to soften that glue. Then you'll need some OCA glue remover to clean...

Not the ones made by chungwha. The colors aren't as good. They seem a little dull and blacks aren't as black, more of a dark gray. Try to get an original Hydis. If you can reuse your old silver bezel, you can get just the digitizer & lcd. If not, you'll have to get the whole assembly: digitizer...

I'm having trouble flashing this. I keep getting the message that it is not intended for this device. I'm using TWRP 2.6.3.0 and RastaKat 4.4. Any ideas? Sent from my Nexus 7 using Tapatalk

Thank you for the illustration. I have the adhesive strips to attach the digitizer to the silver bezel in the areas you've highlighted. What I'm wondering is which type of adhesive would be best to use between the digitizer and lcd, LOCA UV glue or an OCA pad like the one mentioned a few posts...

Do you mean adhesive strips around the bezel only or between the digitizer and lcd? Sent from my Nexus 7 using Tapatalk 4

Has anyone tried an OCA pad or LOCA to glue the digitizer to the lcd yet? I'm gathering materials now. I have everything to separate the two but trying to decide which route to go to put it all back together. Sent from my Nexus 7 using Tapatalk

Verified that bluetooth share works on stock KitKat. Anyone else having trouble tethering via bluetooth? Sent from my Nexus 7 using Tapatalk 4

rascarlo, any thoughts on the Bluetooth share error I'm having (post #2430 above)? Sent from my Nexus 7 using Tapatalk 4

Anyone having Bluetooth trouble? I use Bluetooth auto connect & Bluetooth auto tether to tether to my Galaxy s3. Works fine with latest RasbeanJelly but with Rastakat I keep getting the error message "Bluetooth share has stopped". The Bluetooth connection keeps cycling and the error message...

Having a bit of trouble flashing Rastakat. The flash fails and I get: Set_metadata_recursive: some changes failed E: error executing updater binary in zip Error flashing zip I'm coming from the last RasbeanJelly + Trinity & I've tried both dirty flashing as well as wiping then flashing. Any...

Any progress? Sent from my Nexus 7 using Tapatalk 4