Recent content by mickeymkd

Are you experiencing dot pattern apearing in yellow or red colour in pictures taken eith google cam port on redmi 5 plus when hdr is enabled?

I have done it with Orange Fox Recovery. The steps are the same as in the first post. I am on miui 10.0.2.0 Global.

It doesn't seem to work on MIUI Global 10.0.2.0. I have tried it couple of times without success. Does it work on MIUI 10 or I am doing something wrong? I have unlocked the bootloader only for this.

how can i mount the second system partition, and how to copy its content to PC?

The currently mounted partition is mmcblk0p2. Its the partition when the tablet boots normally. When i try in recovery to flash the latest firmware from sd, on first boot when the tablet gets stuck on sony logo, the flashing process is successful., but when i try the same procedure on second...

I have the same problem, have you found a solution?

How can i check which system partition is booting from, is it system 0 or system 1? When it boots up normally i cant find the recovery.log because there is no /tmp partition?

Hi, I have Sony Tablet S with 4.0.3 R5a which was rooted with condi AIO tool, and also i had installed the mods: Install init.d support, Install "rescue-backdoor". I wanted to return it to stock, so I unrooted it with condi AIO tool, and did a factory reset. After the reset i went in recovery...

Is it possible to remove the mods (return to default) without unrooting and factory reset? I see some of the tweaks return to default when i run them again, but what about Increase SD/extSD read speeds,Install gps-fix mod, Install init.d support, Install "rescue-backdoor"?

Does the factory reset removes the mods and tweaks that were previously applied with the AIO Tool? From recovery mode, can i reflash again the latest OTA firmware signed-nbx03_009-ota-121116046.zip for my device?

Is it possible to return to stock (factory conditions) Sony Tablet S that is rooted, and if so what is the correct procedure? The tablet is on ICS 4.0.3(r5a).

I have installed aokp_primou_unofficial_Nov-24-12 ROM with kernel Hellboy #201212251747, but the camera doesnt work as it should. There is a green tint when the picture is taken, and when i tap to focus the focus square is always red, it never turns green. On stock ROM camera works fine. This...

I am on 2.22.401.1. Which r1-primo-superboot.zip should i use to root the phone?

Whats the difference between: r1-primo-superboot.zip and r1-primo-2.09-superboot.zip? Do i need the modded boot.superboot.img with r1-primo-2.09-superboot.zip?

Is it possible to replace the front cover without disassembling the whole phone?