Recent content by xbamaris1`

Network Signal Guru will have an option to turn off / on bands. It will give you an idea if the bands are at least detected by the system.

Thought so, just wanted to make sure. https://imgur.com/a/WZvKteM is what I get. Is it possible to go back to an earlier RAW rom? I want to see if theres something in earlier ROMS that will make it work. I'm just at a loss. I'm not sure what I'm missing for this to work.

There are band checking tools on the Play Store. Try Network Signal Guru and see.

What does it say for you? It won't find it if you turn it off. What is the COM port / driver that shows up in Device Manager

Open up QPST Configuration > at the top click Server > then Stop QPST Server. After that, see if efsTools give you anything. (efsTools efsInfo)

Make sure you dont have QPST server running. Its not required if using the tools. I ran into this issue and realized thats what it was that was using it.

I changed it to that, I'm even trying this on a completely different computer to see. Now its on COM3 on the different system with that driver. I even recently did a full WW firmware flash and factory reset as well. So its pretty much completely stock other than Root and the Apps you made /...

I cannot for the life of me get either method to work. Connected via USB. DIAG mode driver is loaded on COM1, even changed Baud rate on the COM port in device manager to 38400. USB method gives me "Critical Error: Bad Command" Remote method does not send any information but indefinitely runs...

Same boat as you. anything I try to get any information with ESF Tools errors out with Operation Timed out, Never been able to view anything from QPST from it even if it has SDM855(0). Is there something we're missing?

Thats what I have now, and usually do have when I enable it. I just thought it was strange when I suddenly got that other interface to connect. Again, not sure the significance of what I had since QPST still didn't work. But just was something I came across while trying to tinker.

Yeah it shows up as a USB device with SDM855(0) as the device. I actually had a different diagnostic driver that was the ANDROID Diag mode at some point, not sure if that was useful at all, but still no QPST data. Not sure how I managed to get the Qualcomm ANDROID Diag to show up (The exact...

I really hope we can get QPST fully working. I'm in the same boat as you, was able to get SDM855(0) but nothing after that with QPST. Glad you got it to work though! I really want to try enabling some LTE bands (just want two as a start, 12 / 17. And MAYBE 66.

I had this problem to until I realized that its network based and your phone should be connected to your WIFI (at least thats what fixed it for me). However, Despite this, i am still not getting data from it. COM30001 from an IP of 192.168.1.211 (which is my phone) and it is still not able to...

Could you provide a guide on how you got diag mode to work? I would be willing to test this for the US side of things.

If you have an AT&T phone, you can ask them to provision VOLTE for it. See if it will provide your phone with an IPv6 address from AT&T. An IPv6 will show up if your sim/account is properly provisioned, In my case I was stuck because of a pretty deep error in their system after I was swapping...