Recent content by Yin-Yang

It surely does make no difference if you score high or low. What matters is that you should be satisfied with ur phones performance. Sent from my GT-N7000 using xda app-developers app

This Kernel has MMC_CAP_Erase disabled & so is safe to flash & wipe from.

By the Way if your problem is solved just change the OP title to Solved..

You just need to flash the file through CWMR. But you need to be on a safe kernel first..Just ensure that. Another way is to flash through Mobile Odin Pro.

Although I like flashing & experimenting, I have not tried doing this & I doubt it will work.

Have you tried to change the Network mode to WCDMA only. Am in India & for 3G only I keep the setting to WCDMA only, so that it does not go to EDGE/2G speeds.. But it may be different for your carrier. Wait for somebody from your location or with knowledge of the same to answer..

Gapps are ROM specific for many custom roms, as the developer has tweaked it to be compatible with his rom. I dont think it if you flash Gapp of one ROM with any other ROM it will work. What exactly do you have in mind.. Which Gapp & ROM do you need to flash?

I think you need to read instructions to the point before carrying them out. I had posted you the method for installation of PA which so far as I know is the correct one coming from any non AOSP based ROM. Pls. do follow the instructions. In case you are in doubt just ask for a reconfirmation...

Pls provide details of what you did before such a thing happened.... Like flashed some files/roms/themes, etc..

Just check the sticky thread in development section for various custom roms & their features. If it suits your taste you can try to install it. For me Paranoid Android 2.1 by Imilka is good JB ROM. Just keep a nandroid backup of your current ROM. Try flashing various roms following the...

Since you are on Hydracore it is safe to wipe. But just to be sure just take a nandroid backup, by Booting in to recovery Selecet Backup & restore--> Select Backup & do a nandroid backup Then just follow the installation procedure below Keep both the ROM & Gapps file on your SD card Wipe data /...

I would like to point out that the Kernel Cleaning Scripts have been found to do no good or bad and hence not required to be flashed. You just need to be on a safe kernel & do a full wipe to install the ROM. Also, for the first time install of the ROM it is recommended to flash Hydracore Std...

Finally am on PA. Thnx a ton mate.

Tried twice to install PA 2.1 coming from KD 4.4 (Hydracore 4.3b & Hydracore 5.1), but am stuck on the PA Boot Logo (waited for 15-20 mins), after it shows that android is upgrading. Followed the OP instructions to the point... full wipe (/system, /cache, /dalvik) followed by installing the ROM...

Pls. give details. What steps you follow & which version of KD are you falshing By the way it takes more time than normal, immediately after flashing, to boot for the first time