Remove All Ads from XDA

About Me

  • About ndt44
    Service provider
    U.S.A. - AT&T
    Home country
    United States
    LINUX (going back several years), computers, electronics, soldering, welding, hot-rodding


Total Posts
General Information
  • Last Activity: 10th December 2019 11:10 PM
  • Last Login: 1st January 1970 01:00 AM
  • Join Date: 1st January 2015
  • Referrals: 0

Most Thanked

Post Summary
I was finally able to use TWRP 3.3.1 Install to flash file "" this morning and rid myself of the Orange State warning every single boot. NOTE: I had to UNCHECK zip file verification in TWRP Install in ...
While I am focusing this thread only on Armor 6.. To keep this thread focused on the Armor 6 only, I have posted my work/results on rooting and Orange State with my Armor 6E here for future reference:
While I am focusing this thread only on Armor 6, I am not sure if this command will work for the 6E, however try, "fastboot flashing unlock" Let me know if it works or not. Good luck. That worked to unlock it. I kept getting authentication error...
How do I enter recovery mode? Which model of DuraForce are you working with? That apparently makes a big difference in the DuraForce Pro.
Has anyone succeeded in flashing and/or rooting the DuraForce Pro? Mine is an E6820 AT&T variant, and I haven't been able to get in either bootloader or recovery mode with the various key combinations found online. The E6810 and E6830 versions all...