Its probably because you sent the VSCs directly from libbt-vendor, rather than sending an opcode command from VendorInterface, which then sends VSCs, and thus the VendorInterface considers the last internal opcode(BT_VND_OP_LPM_SET_MODE in this ca...
Sorry for delay. I was a bit busy today. Here is my workaround for bt issue:
2) device tree
Honestly this workaround is terrible (explanations will be provided below) and disabled by default. You ...
LineageOS 17.1 is a free, community built, aftermarket firmware distribution of Android 10.0 (Q), which is designed to increase performance and reliability over stock Android for your device.
* Your warranty is now void.
I've build new version of LOS:
This version includes fix for calls via bluetooth!
I'm not sure that fix will work in all cas...
If i understand correctly this is just a warning that the hci module doesn't recognize the command, which I believe is normal since the call is not made from the bt stack( which is not quite needed at this point anyway).
This is partly true. This...