Any one have issue enabling NFC? It used to work on stock rom.
04-30 10:23:48.516 1959 6029 E NfcAdaptation: NfcAdaptation::Initialize: ver=NFCDROID-AOSP_N_00.01 nfa=NFA_PI_1.03.66+
04-30 10:23:48.519 1959 6071 I BrcmNfcNfa: NFC_TASK started.
04-30 10:23:48.520 1959 6029 E NfcAdaptation: No HAL module specified in config, falling back to BCM2079x
04-30 10:23:48.521 1959 6029 E NfcNciHal: HaiInitializeLibrary: ver=NFCDROID-AOSP_N_00.01 nfa=NFA_PI_1.03.66+
04-30 10:23:48.533 1959 6029 I USERIAL_LINUX: USERIAL_Init
04-30 10:23:48.534 1959 6029 I NfcNciHal: HAL_NfcInitialize (): NFC_HAL_TASK id=0
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_dm_init ()
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_sys_register () id=1, enable_cplt_mask=0x0
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_sys_register () id=3, enable_cplt_mask=0x8
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_rw_init ()
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_sys_register () id=6, enable_cplt_mask=0x48
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_ce_init ()
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_sys_register () id=7, enable_cplt_mask=0xc8
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_ee_init ()
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: nfa_sys_register () id=2, enable_cplt_mask=0xcc
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: LLCP - llcp_init ()
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: num_rx_buff = 9, rx_congest_start = 6, rx_congest_end = 4, max_num_ll_rx_buff = 2
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: max_num_tx_buff = 21, max_num_ll_tx_buff = 6
04-30 10:23:48.534 1959 6029 I BrcmNfcNfa: LLCP_RegisterServer (): SAP:0x1, link_type:0x2, ServiceName:<urn:nfc:sn:sdp>
04-30 10:23:48.535 1959 6029 I BrcmNfcNfa: LLCP_RegisterServer (): Registered SAP = 0x01
04-30 10:23:48.535 1959 6029 I BrcmNfcNfa: NFA_Enable ()
04-30 10:23:48.536 1959 6071 I BrcmNfcNfa: NFA got event 0x0100
04-30 10:23:48.536 1959 6071 I BrcmNfcNfa: nfa_dm_evt_hdlr event: NFA_DM_API_ENABLE_EVT (0x00)
04-30 10:23:48.536 1959 6071 I BrcmNfcNfa: nfa_dm_enable ()
04-30 10:23:48.536 1959 6071 I BrcmNfcNfa: NFC_Enable ()
04-30 10:23:48.536 1959 6071 I BrcmNfcNfa: nfc_set_state 0 (NONE)->1 (W4_HAL_OPEN)
04-30 10:23:48.536 1959 6072 I USERIAL_LINUX: USERIAL_Open(): enter
04-30 10:23:48.536 1959 6072 I USERIAL_LINUX: USERIAL_Open() device: /dev/bcm2079x-i2c port=5, uart_port=0 WAKE_DELAY(20) WRITE_DELAY(20) POWER_ON_DELAY(50) PRE_POWER_OFF_DELAY(10) POST_POWER_OFF_DELAY(0)
04-30 10:23:48.536 1959 6029 I BrcmNfcNfa: NFC_SetTraceLevel () new_level = 1
04-30 10:23:48.597 1959 6072 I USERIAL_LINUX: USERIAL_Open(): exit
04-30 10:23:48.597 1959 6072 E USERIAL_LINUX: USERIAL_Write len = 4, ret = -1, errno = 5
04-30 10:23:50.660 1959 6029 D : phNxpLog_InitializeLogLevel: global =1, Fwdnld =1, extns =1, hal =1, tml =1, ncir =1, ncix =1
04-30 10:23:50.661 1959 6029 E BrcmNfcJni: nfcManager_doInitialize: fail nfa enable; error=0x0
04-30 10:23:51.564 1959 6071 I BrcmNfcNfa: GKI TASK_DEAD received. exit thread 3...
04-30 10:23:51.765 1959 6029 W NfcService: Error enabling NFC