[AKT] Advanced Kernel Tweaks v1.6 FINAL | Insane Battery & Performance(SD820/1|OP3/T)

@Eadaro
I conclude that with ElementalX does not need to apply the tweak at every reboot.
Thank you, very much

flar2 wrote:
"Init.d has not worked reliably since before Lollipop, so no, it's not supported. You should use SuperSU and su.d instead."
Unfortunately, Elementalx and bluespark does not support init.d
Too eng.stk wrote:
"init.d support (put your scripts in /system/su.d or /su.su.d)"*
@Asiier
Can I change the path of the file after using the AKT command?

from "/system/init.d/99AKT" to "/system/su.d/99AKT"

In your opinion, it would correct this procedure?
Thank you, very much.

Sorry, your question better to wait for Asiier's answer

but after reboot when i check it shows active profile as what i have selected before.. does it mean its working without having to apply a profile on every boot?
thanks in advance for clearing my doubt.

Send From Oneplus A3003

I found I had better success with the file in su.d than in init.d

now i have the file in both su.d (copied from init.d) and initd locations. how can i confirm if its working without needing to apply profile in terminal on every reboot... thanks for your reply..

Send From Oneplus A3003

@Asiier @Mostafa Wael
Finally managed to get the AKT working on Experience ROM 7.0

Just followed this sequence (not sure if it is related to each other )
Clean flash the 9.6 Experience ROM
SuperSU
Reboot to system
Reboot to recovery. Instal ElementalX Kernel and then AKT 1.0
reboot and then Terminal (grant super rights) and then work on AKT.
Voila ....Xana profiles work.... working perfectly.

Thanks guys

@Asiier @Mostafa Wael @patalao and senthil

Wanted to leave a few pics as a testimony to the wonderful work you guys have done...still more than 50% juice left...

Plz pardon me for the large pics...courtesy the legacy app
Attachment 4012940Attachment 4012941

Sent from my ONEPLUS A3003 using XDA-Developers Legacy app

1. Can anyone please explain the difference between input boost and touch boost? (I use kernel adiutor)

2. I have enabled "apply on boot" for the tweaked settings (Project x.a.n.a applied through terminal) via kernel adiutor... I think that doesn't require me to apply via terminal after every reboot, right?

I don't think step 2 is in any of the Instructions for AKT.......So I would assume you STILL need to apply via terminal after every reboot. I bet there are settings that AKT applies which are not discretely covered inside Kernel Auditor and the "Apply on Boot" options....this is why AKT apply via terminal is necessary

Don't want to spoil the surprise, but I just downloaded AKT 1.2 from @Asiier his page on AndroidFileHost

Hahaha, you were faster than me buddy!

how to use tasker to execute command at boot? can someone tell me step by step instruction?

Send From Oneplus A3003

I'd like to release my AKT Profiles App

Thankyou to all involved in AKT and all the slack channel for helping me test and improve the app.
What started as just some experimentation with tasker, evolved into a complete app.