Search results

Where to donate?

Maybe just lsusb command

per app volume and outputdevice control, i'm missing most in Android. Is there something similar you know?

Interesting My Pendant is at 6.2.1.0 (Build NS6210/397), any chance get a working payload? I can upload Files if it helps... sorry for my english... ;) ---------- Post added at 10:43 PM ---------- Previous post was at 10:32 PM ---------- Many times the DFU mode did´nt kick in, than i hooked...

I followed [GUIDE] [UPDATE 3] How to enable Google Assistant on your phone (Android 7.0+ only) by brianelv Now Google voice works ---------- Post added at 02:58 PM ---------- Previous post was at 02:42 PM ---------- My fault, its Google Assistent not voice

75ms? An blink of an eye takes about 100 to 400 milliseconds, you should´nt blink to much for not missing fast response ;)

ok google Hello I have installed LOS yesterday, :good:. My little Feedback... First Problem i stucking at can´t get Google Voice to run. I have tried remove Microfon Permissions of every app except Google. I´m @ latest LOS with opengappsnano.

Donation is on its way...

yep that´s a problem! I could´nt make into recovery with LL10" unit per original buttons. - maybe real hardwarebuttons required... For 4.x.x units there was a hardware hack that will give buttons to units don´t have. The PCB of LLunits is different, so someone needs to check routing and share...

I have 10" unit. For recovery make root and then use rebootapp for "boot to recovery". In recovery use usbkeyboard... nice

yes, i left the sdcard inside of the metalbox and now i can copy to it... I have my 10"JY since yesterday. ;) like it... Can´t wait for car install...

yes, LP can´t beet KK in battery life

Have a break, have a KITKAT

Using KK and Battery goes fine

so on, thanks for 12.1 :good:

Yes, while using Navi App and loading in Car Batterie goes empty. I have build in new Akku, but that doesn´t the Trick! Is it maybe because of thermalmonitor it didn´t load enough?

Place the phone on a heatable-3dprinter-bed and warme it up the temperature you want - digitizer was falling of the display last time i repaired my z1. I heated it up to disassemble. Now it is cracked again and i just don´t know how to glue the digitizer on... If i would change digitizer ;)

Me too, sometimes touch didn´t recognice anything - else :good:

It´s Alive - Yeah!

1. fastboot flash boot boot.img 2. recovery update to 02.14 3. reboot seems to work

about "set SELinux to Permissive" , yeah, in cm12 honami that´s the trick - thumbs up!

Recovery is alive again, since 20150204-Nightly - thumbs Up!

I have entered recovery a lot. If purple light press up. But actualy it won't work :(

Vol Up to enter recovery is working - not for me :( still only boot into recovery is working

Will try again. two times [email protected] Second try i have used an app and replaced the bootanimation but it wasn´t - **** happends... Now @ third try I will simply delete with totalcommander /system/media/bootanaimation file. Maybe - will report! Edit: yes reboot succes

same here! Cm12 update 31.01. installed, reboot at bootanimation stuck and can´t enter recovery ... will go fastboot