very very thanks for this rom..after flash magisk 19.3 trusted face force close and dont work..
please how can i fix this problem???
please how can i fix this problem???
[ROM][9.0][Xiaomi Mi 9][unofficial] ViperOS v6.5 [2019/06/27]
- Thread starter raystef66
- Start date
NEW MI9_china_V9.6.27_vendor_fw_flash
Tested and working on ViperOS, crDROID. Should work on PE too
Install :
1. wipe vendor
2. mount vendor
3. flash zip
4. reboot - done !
Tested and working on ViperOS, crDROID. Should work on PE too
Install :
1. wipe vendor
2. mount vendor
3. flash zip
4. reboot - done !
Nice! Fingerprint is working! It needs a bit of optimization tbh, also it does not work on always on display, but the ROM is smooth overall
Better as on pixel experience?
---------- Post added at 07:46 PM ---------- Previous post was at 07:39 PM ----------
Nice! Fingerprint is working! It needs a bit of optimization tbh, also it does not work on always on display, but the ROM is smooth overall
NEW MI9_china_V9.6.27_vendor_fw_flash
Tested and working on ViperOS, crDROID. Should work on PE too
Install :
1. wipe vendor
2. mount vendor
3. flash zip
4. reboot - done !
Thank you!
What are the benefits?
In my opinion viper OS is a lot more responsive, smooth has a lot more customizations and above all a lot more to see in the near future, thanks to OP cheers.
NEW Viper-cepheus-20190627-v6.5-UNOFFICIAL
Added FP at last :cyclops:
....
Clean flash recommended
E N J O Y
Hi, face unlock and voice match don't work, is this related to vendor or can be fixed
I have a question for the developer. Why did you build this operating system an give flashing instructions when it simply will not flash under any circumstances and only causes fastboot loops that cause wear an tear on my Mi9 because yoiu have to use miflashpro to force a firmware flash/
seriously dude?You need to realise this OS does not work an softbricks phones?
And you need to get it togeather so that if it works people can enjoy it.
Because its unbootable as it stands.
And that isnt a criticism its a solid fact!
It has caused me about 6 fastbootloops
seriously dude?You need to realise this OS does not work an softbricks phones?
And you need to get it togeather so that if it works people can enjoy it.
Because its unbootable as it stands.
And that isnt a criticism its a solid fact!
It has caused me about 6 fastbootloops
easy setup and same response as PE
up to you to test
known issue - hope we get that working too
Such responses are below any level but I leave that up to you. I put a lot of time into this and really these comments are inappropriate tbh...
This ViperOS boots outstanding. Ask others....
You're doing something wrong maybe
no I do not agree, no one forces you to use the Roma that others give you for non-profit. if you do they are your *****. If you think you do better, get busy.
You must be doing something wrong for sure cos think about it no one else getting any problems but you, and there are better ways to ask people for help, with this attitude you gonna get even more frustrated and might end up bricking your phone, I suggest you calm down and discuss your problem in a friendly way and everyone will help you solve your problem. So what rom have you got on your phone atm? give us the stats without any criticism and let's see if we can get you going, cheers
robygt
Senior Member
Attachments
Hahahaha, Just 6 !!!!!! Really only 6 bootloops...... Holly macaroni , please do us all a favour and delete your Account.....
From the Moderator oka1
Complaining when you have a problem without researching if others have had and what they tried to resolve is
Well ............ it is called Whining.
IF you have a problem Identify the problem, post a logcat if you want help in resolving. Remember, most phones today are not built in the same factories and may not have identical components ........just another issue that can cause potential issues as well.
Do not Whine, do not post disrespectfully, that gets you into trouble in XDA.
If this does not work for you then do one of 2 things .........
1. Move on to another custom ROM .... or .......... Make your own ROM for us to critique.
~~~ oka1
Complaining when you have a problem without researching if others have had and what they tried to resolve is
Well ............ it is called Whining.
IF you have a problem Identify the problem, post a logcat if you want help in resolving. Remember, most phones today are not built in the same factories and may not have identical components ........just another issue that can cause potential issues as well.
Do not Whine, do not post disrespectfully, that gets you into trouble in XDA.
If this does not work for you then do one of 2 things .........
1. Move on to another custom ROM .... or .......... Make your own ROM for us to critique.
~~~ oka1
Followed the steps and after hitting boot to system it keeps blinking the 'MI unlocked' repeatedly. Feels like a bootloop
I have a question: why with PE you can simply flash and it will work nicely even if u have data partition encryted while with this one you have to format data or else with wont boot at all?
Last edited:
You can boot this rom without format data. No problem with that. It's just a step I add to rule out any conflicts. But you can easily swipe to factory reset, reboot recovery again, wipe system, dalvik, data, flash viper, flash gapps, reboot twrp (I do it like this but it's up to you to do it your way) flash magisk and boot into system.
As said, my steps are not obligatory. It's just a clean flash.
I did exactly as you said yesterday and it didn't work. It would go back to recovery every time.
But flashing PE boots just fine.
Similar threads
Top Liked Posts
-
There are no posts matching your filters.
-
31
JUST FOR FUN...no more no less...
Based on @markakash device, kernel & vendor with known current issues
Feature list :
Always take a proper backup of your running device !
Installation:
0. unlocked, suited twrp like 3.3.1-30
00. running global or PE
000. boot into twrp, format data, swipe to factory reset, reboot back into twrp
1. Copy latest Viper-cepheus-20190627-v6.5-UNOFFICIAL zip, f.e. micro gapps zip and latest magisk to internal/ext OTG
1a . download MI9_Global_V9.5.30_vendor_fw_flash and also put it on internal/OTG
2. wipe system
3. flash MI9_Global_V9.5.30_vendor_fw_flash.zip (or 9.6.13) or latest : MI9 xiaomi.eu V9.6.20 vendor_fw flash
3a. if you want your phone decrypted flash : Mi9_vendor_decryption
4. Flash ViperOS
5. Flash gapps
5a Reboot and setup phone
6. Flash Magisk 19.3
7. Reboot and enjoy !
note : rescale corner display cutout (when statusbar left and right are too wide) under display/display cutout
Contributors
@raystef66
Credits to
ViperOS Team
@markakash
@ZoiraP
Source Code: https://github.com/ViperOS/viper_manifest
Device, vendor & kernel Source:
https://github.com/markakash/device_xiaomi_cepheus
https://github.com/markakash/kernel_xiaomi_sm8150
https://github.com/markakash/vendor_xiaomi_cepheus
ROM OS Version: 9.x Pie
ROM Kernel: Linux 4.x
ROM Firmware Required: Latest Miui Global Stable
Version Information : 9.0 v6.5
Status: Beta Stable with known issues (PE)
Sec. Patches : 2019-06-05
Created : 2019.06.17
Last Updated : 2019.06.1811NEW Viper-cepheus-20190627-v6.5-UNOFFICIAL
Added FP at last :cyclops:
....
Clean flash recommended
E N J O Y7
That's correct - unfortunately FP is still to be fixed on these builds . PE has a working one though if needed. These are first builds and are under improvement
FP patch should be working in next build.6
For those who want decryption on ViperOS, I made a zip that can be flashed before first boot or after ofc. (but remember you'll loose data because you'll have to format)
I changed the fstab.qcom and afaik will work on all vendors like 9.5.30, 9.6.13 and latest 9.6.20 using ViperOS
We tested on stock roms too but till now it wasn't successful. You can use the dm-verity zip on stock rom if you want.
Mi9_vendor_decryption
How to use :
1. format data, factory reset, reboot twrp
2. wipe system and flash ViperOS
3. if needed flash latest MI9_xiaomi_eu_V9.6.20_vendor_fw_flash
4. flash Mi9 vendor decryption
5. boot rom
6. done
You'll notice upon boot that phone is decrypted in settings.
To revert back simply format data again and reflash 9.6.20 vendor again and reboot
ENJOY
thnx @smeroni68 for testing with me :highfive:6NEW BUILD Viper-cepheus-20190622-v6.5-UNOFFICIAL
ADVICE : flash CLEAN ( format/factory, reboot twrp, wipe system, flash ViperOS, gapps, reboot twrp, magisk, boot )
You can either use the 9.5.30, 9.6.13 or my newest MI9_xiaomi_eu_V9.6.20_vendor_fw_flash
*updated to latest device, vendor & kernel tree @markakash
*added NFC
*auto brightness
....
Whats working for now?
Wifi
RIL
Mobile data
GPS
Camera
Flashlight
Camcorder
Bluetooth
Sound / vibration
Wireless charging
Double Tap to Wake
Brightness slider
Still broken
Notification light
FP
Hopefully next build will add FP
E N J O Y
