After flashing HardSPL you'll be able to flash any Kaiser ROM to your device!
This tool will allow you to change the ROM language, flash cooked ROMs, custom splash screens, etc...
FEATURES
- SuperCID / Security Level=0
- Does not check NBH signatures
- Based on 1.50 MFG bootloader, rtask enabled
- Accept any password
- Model ID check only 4 chars
- SPL overwrite DISABLED (to bypass, use SSPL-KAIS.exe)
INSTRUCTIONS
- Connect Kaiser to computer using USB cable
- Make sure ActiveSync icon is GREEN
- RUN kaiser-HardSPL.exe on Computer (PC)
- Follow instructions on screen:
Code:
*****************************************************************************
XDA-Developers HTC KAISER CID Unlocker by pof
HTC TyTN II P4550 / T-Mobile MDA Vario III / AT&T Tilt (8900, 8915, 8925)
Swisscom XPA 1605 / Vodafone v1615 / Vodafone VPA Compact V / SFR v1615
Features:
1. SuperCID / Security Level=0 2. Does not check NBH signatures
3. Model ID check only 4 bytes 4. Based on MFG bootloader, rtask enabled
5. Accept any password 6. SPL overwrite disabled
This software is free to use but at your own risk, I take no responsiblity
for any conflict, fault, or damage caused by this unlocking procedure.
No warranties of any kind are given, any commercial use is prohibited.
Your donation is a strong incentive to continue research on new devices,
if you find my work useful please cosider making a PayPal donation to:
pau@eslack.org
Any donation amount is greatly appreciated :-)
*****************************************************************************
Please make sure ActiveSync is enabled (GREEN icon in systray)
and hit ENTER to start...
Kaiser JumpSPL is running on your device, please check your device
screen and follow the steps until you see the tri-color screen.
When done hit ENTER to continue...
Device screen should be now TRI-COLOR and show "USB"
===> PLEASE UNPLUG AND RE-PLUG THE USB CABLE NOW <===
===> PLEASE UNPLUG AND RE-PLUG THE USB CABLE NOW <===
===> PLEASE UNPLUG AND RE-PLUG THE USB CABLE NOW <===
ActiveSync icon should become gray after that.
When done hit ENTER to continue...
Phone screen should now be tri-color and the activesync icon gray
if not, the loading process has failed and you'll have to repeat it again.
If all was OK hit ENTER and the standard "PDA Phone ROM Update Utility"
window will start, allowing you to flash HardSPL on your device.
Hit CTRL+C to Cancel or ENTER to continue...
Follow the steps on the wizard to flash HardSPL, when finished your
device will reboot. It should last no more than 1 minute.
- Launching RUU, please wait...
Process is finished, congratulations!
If you find it useful don't forget to donate :)
*****************************************************************************
(c)2007 pof - XDA Developers
Hit ENTER to quit.THANKS TO:
- Esteve, Olipro, arc, pancake, HaRET developers, and everyone else who I forget...
without your help this wouldn't have been possible!DISCLAIMER
This software is free to use but at your own risk, I take no responsiblity for any conflict, fault, or damage caused by this unlocking procedure.
No warranties of any kind are given, any commercial use is prohibited.
DONATIONS
Your donations are a strong incentive to continue research on new devices, if you find JumpSPL useful please cosider making a PayPal donation. Any donation amount is greatly appreciated
Enjoy!
Last edited:
