Hello Defyers
I have an Old (small pin) nokia car charger its specs as the following
- Input 12v DC
- output 5.7 V 890 mA
I want to convert this small pin charger to a micro USB by some cutting and wiring
My concern is... if i use this charger with my Defy will i fry it...
its standard charger produced 5V , 850mA
with that 0.7V difference i might overload my circuts but it will work in the end
or i will end up with a black shiny brick
my defy is over clocked and running CM7
I have an Old (small pin) nokia car charger its specs as the following
- Input 12v DC
- output 5.7 V 890 mA
I want to convert this small pin charger to a micro USB by some cutting and wiring
My concern is... if i use this charger with my Defy will i fry it...
its standard charger produced 5V , 850mA
with that 0.7V difference i might overload my circuts but it will work in the end
or i will end up with a black shiny brick
my defy is over clocked and running CM7
Last edited: