:angel:NOTE:- You should have your Bootloader unlocked. I don't hold any responsibility if you brick your device.
Unbrick Your Moto G by restoring to Kitkat From Lollipop.
STEPS:-
1.Download & install this ADB Drivers - http://bit.ly/ADBdrivers
2.Download the Firmware according to your model -
3.Download This Mfastboot-v2 - http://goo.gl/5GPn1o
4.Extract the Downloaded File Mfastboot-v2 & Firmware into the same folder.
5.Put the phone into bootloader mode by Holding the POWER + VOLUME DOWN for five seconds.
6..Connect the USB Cable.
7.On PC Hold shift & right click inside the folder & hit Open Command Line Here.
8.Now Flash These Code One By One Very Carefully.
Code To Be Flashed:-
Code:
mfastboot flash boot boot.img
mfastboot flash recovery recovery.img
mfastboot flash system system.img_sparsechunk.0
mfastboot flash system system.img_sparsechunk.1
mfastboot flash system system.img_sparsechunk.2
mfastboot flash modem NON-HLOS.bin
mfastboot erase modemst1
mfastboot erase modemst2
mfastboot flash fsg fsg.mbn
mfastboot erase cache
mfastboot erase userdata
mfastboot rebootRemember- Flash using the following commands only as they have skipped bootloader and partition table file of kitkat or you would HARD-BRICK your device.
Also See,
Full Written Guide - http://geekstay.com/?p=138
If u face any issues,tell me in the comment below.I would Love to HELP!!!
Pls Subscribe to my Youtube Channel If I Helped!!
Last edited:
