Hi,
I do not speak English, so I am sorry for my bad English.
I have a P920 and I installed this app, but it does not run. I make a missed call to myself, but the leds do not light.
Thank you very much!
Your English is fine
Have you rooted your phone ? You could check out the thread in the Optimus 3D-subforum, there is currently another developer working with the app for the P920 and he might be able to help you out.
Hi,
This app is working on gr 4 but each time I reboot, I've a message that says ' superuser permissions refused for LG 2X./Black .....'
Sent from my LG-P990
That sounds strange, it seems the Superuser-app might be configure wrong for the app. If you open the Superuser-app then you can perhaps change so it wont refuse permissions for the app.
I was using this great app with LG Optimus Black stock roms like v10b/c/e, but i can't do it with CM7 nightlies right now. Everytime I open app it says "App detected it has no read or write access to a required file, do you wish to fix this?" I click OK, but still doesn't work.
This message appears everytime I open the app. What could be the problem here?
Thanks in advance.
What happens when you click OK ? Does it say anything or does it seem to work normally ? Did you ever get a question about allowing Superuser-permissions ?
CM7 have their own notification built-in so there might be a conflict, you could try and disable it.
Love the app, just what my G2x needs. Your hard work and dedication are much appreciated.
I do, however, have one problem maybe you or the other fine members of this forum can help me with.
I have a notification ringtone set to go off every 5 minutes after a missed notification. Works great, I love it, wish I had it earlier. However, in the morning it goes off because of the battery 100% notification. Is there a fix, workaround, or setting that I'm missing? (I've searched quite a bit but only see discussions with the SGS2) As long as the circuitry shuts down, I don't care about that notification.
I never experienced this. Are you using a third party-app that puts a notification in the notification bar when the battery is fully charged ? If so you might have to exclude that activity (Notifications -> Exclude activities). If you're uncertain which activity it is you can log notifications in the Advanced-menu and then check the log when it happened again.
@xigzil
How to fully disable the accelerator/g-sensor for power saving ?
why do you have this build in?
without this, i would say its a wonderful valueable app ,with it have to deinstall the app ):-
thanks
The accelerometer can't be disabled. It is used by the app to determine if the phone is being used. For example, you're writing an e-mail on your phone and gets an SMS. At this point the app enables the accelerometer to detect user activity, if it detects activity (by movement of the phone) it disables the accelerometer and doesn't do anything more. If the accelerometer were to be disabled it would start the notification as soon as the screen turns off since it doesn't know if the phone has been used at any point after the notification has been received, which would be quite bothersome.
It might not be the best solution but I haven't found anything else and it works pretty well.
Normally this shouldn't use a lot of battery at all though, since when it is started it is usually only enabled for a couple of seconds. Does it use an unusual amount of battery for you ?