FORUMS
Remove All Ads from XDA

[Tutorial]How to flash Stock firmware[Get your warranty back]

724 posts
Thanks Meter: 1,778
 
By Omkar$, Senior Member on 31st October 2013, 01:27 PM
Post Reply Email Thread
12th May 2016, 11:58 PM |#61  
Junior Member
Thanks Meter: 0
 
More
firware download link dead
 
 
1st June 2016, 12:31 PM |#62  
Senior Member
Thanks Meter: 5
 
More
Omkar$, does that procedure apply to most Samsung devices?

I have an S5 Plus (G901F), currently on Kitkat (T-Mobile), which I want to flash to 6.0.1 (official, not custom!)
Do you think I can I follow the same steps as you mention here?

(couldn't find a guide specific for that phone...)



Quote:
Originally Posted by Omkar$

This tutorial shows you how to Flash stock Firmware using Odin on Galaxy Core Gt-i8262

Requirements :--->

1. ODIN 3.07
2. Samsung USB Drivers
3. Stock firmware
download from post 2
4. Official USB cable
5. Ofcourse Galaxy core

note :-> click on above requirements to download them..

Flashing Tutorial :-->

DON'T FORGET TO PRESS THANX BUTTON FOR MY HARD WORK

1. Install usb drivers on pc....
2. reboot ur pc
3. Download the ODIN 3.07 & save it in your PC and extract its content to Desktop.
4. Download the update firmware.zip && save it in your PC and extract the update file on your Desktop.
5. Now, turn off your Samsung Galaxy Core
6. Boot your Galaxy Core into the Download mode by pressing [ Volume down + Menu + power ] buttons on the same time.



7. now ur phone will boot into download mode ........u will see a "WARNING"


8. now press "VOLUME UP" button to enter into download mode :-->

9. Now open "ODIN 3.07.exe" on desktop & attach ur phone to ur pc using stock usb cable.

10. When the connection is established with odin , u will be notified with the “added” message that will be displayed on the Odin interface, the ID:COM section should be colored on yellow or blue.

11. click on PDA button && select the Gt-i8262XXXXXX_i8262XXXXXX_XXXHOME.tar u extracted on desktop [file name may differ ]

12. now click on "START" button & it will take 10 minutes to flash the firmware ....

Note:-> DON'T interrupt the flashing process, it may brick ur device [ soft or hard brick]

13. U will see a "PASS" & "RESET" on ODIN application...

14. Ur phone will reboot automatically & u should be booted successfully ....

15. enjoy [ u have flashed stock firmware successfully on ur device ].


F.A.Q :->

1.) If the ODIN get stuck ?
ANS:->
Close the ODIN.
Disconnect your device from the PC by removing the USB cable.
again connect the device with pc.
again open Odin
Repeat the tutorial.

2.) If your device gets a Boot Loop [ boot animation agian & agian ] ?
ANS:->
Reboot device into the Recovery Mode [ VOLUME UP + DOWN + MENU + POWER ]
Perform a “wipe data factory reset” and after that “wipe cache partition”.
Then choose “reboot system now”


[Regards,]
Omkar$



Sent from my GT-I8262 using XDA Premium 4 mobile app

1st June 2016, 02:39 PM |#63  
Samuel2599's Avatar
Member
Flag Shillong
Thanks Meter: 25
 
More
Quote:
Originally Posted by jstoner

Omkar$, does that procedure apply to most Samsung devices?

I have an S5 Plus (G901F), currently on Kitkat (T-Mobile), which I want to flash to 6.0.1 (official, not custom!)
Do you think I can I follow the same steps as you mention here?

(couldn't find a guide specific for that phone...)

As long as it's an official firmware :thumbup::thumbup:
11th June 2016, 08:41 AM |#64  
Junior Member
Thanks Meter: 0
 
More
my playstore is not working??give solution
my mobile is GT-I8262D
16th July 2016, 12:17 PM |#65  
Junior Member
Flag Jakarta
Thanks Meter: 1
 
More
There is simple & safe procedure using KIES. Found it on youtube.
There is no fear for wrong firmware download since download perform by KIES.
I just try it with my GT-I8262 using KIES2 since i want get rid of philz touch recovery. However in my case, KIES2 asking S/N, not IMEI. On video he is using KIES3. Of course, you need active internet connection.

https://www.youtube.com/watch?v=LqoX7wNhotk
22nd September 2017, 06:38 AM |#66  
Junior Member
Flag Dasmariñas
Thanks Meter: 0
 
More
Quote:
Originally Posted by Omkar$

This tutorial shows you how to Flash stock Firmware using Odin on Galaxy Core Gt-i8262

Requirements :--->

1. ODIN 3.07
2. Samsung USB Drivers
3. Stock firmware
download from post 2
4. Official USB cable
5. Ofcourse Galaxy core

note :-> click on above requirements to download them..

Flashing Tutorial :-->

DON'T FORGET TO PRESS THANX BUTTON FOR MY HARD WORK

1. Install usb drivers on pc....
2. reboot ur pc
3. Download the ODIN 3.07 & save it in your PC and extract its content to Desktop.
4. Download the update firmware.zip && save it in your PC and extract the update file on your Desktop.
5. Now, turn off your Samsung Galaxy Core
6. Boot your Galaxy Core into the Download mode by pressing [ Volume down + Menu + power ] buttons on the same time.



7. now ur phone will boot into download mode ........u will see a "WARNING"


8. now press "VOLUME UP" button to enter into download mode :-->

9. Now open "ODIN 3.07.exe" on desktop & attach ur phone to ur pc using stock usb cable.

10. When the connection is established with odin , u will be notified with the “added” message that will be displayed on the Odin interface, the ID:COM section should be colored on yellow or blue.

11. click on PDA button && select the Gt-i8262XXXXXX_i8262XXXXXX_XXXHOME.tar u extracted on desktop [file name may differ ]

12. now click on "START" button & it will take 10 minutes to flash the firmware ....

Note:-> DON'T interrupt the flashing process, it may brick ur device [ soft or hard brick]

13. U will see a "PASS" & "RESET" on ODIN application...

14. Ur phone will reboot automatically & u should be booted successfully ....

15. enjoy [ u have flashed stock firmware successfully on ur device ].


F.A.Q :->

1.) If the ODIN get stuck ?
ANS:->
Close the ODIN.
Disconnect your device from the PC by removing the USB cable.
again connect the device with pc.
again open Odin
Repeat the tutorial.

2.) If your device gets a Boot Loop [ boot animation agian & agian ] ?
ANS:->
Reboot device into the Recovery Mode [ VOLUME UP + DOWN + MENU + POWER ]
Perform a “wipe data factory reset” and after that “wipe cache partition”.
Then choose “reboot system now”


[Regards,]
Omkar$



Sent from my GT-I8262 using XDA Premium 4 mobile app

hi your help is very great but you need to update your links on firmware. it not working anymore
Post Reply Subscribe to Thread

Guest Quick Reply (no urls or BBcode)
Message:
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes