Here Here and thanks a lot for re-opening!
Note: EVERYONE (Self Included) PLAY NICE!! This thread is for discussion of MTTY and not alternatives.
If you have an alternative post a thread for your own discussions
Thanks All
MG
Cotulla said:Hello,
task 29 should work.
Seems it's just copy-paste from another function.
It always outputed, so it can be ignored...
-Cotulla
Hi,
After the success of the Diamond Version of this guide I decided to "BRING THE RAIN" over here!! I noticed a post about a rom having random hard resets so I knew my calling was up!!
After what happened in the Diamond thread with the Tourists Im going to try and remove all repeat questions BEFORE they get asked so READ THIS WARNING:
F.A.T.M.T.I.D.Q:
(Frequently Asked TOO Many Times Infuriating Damn Questions):
-------------------------------------------------------------------------
1: "After task 28, I get this output in MTTY: Total Bad Block in CE: x"
2: "After task 29, I get this output in MTTY:
ERASE block xxx FAIL !!!
ERASE block xxx FAIL !!!"
(where x is a random number)
This has been asked 100+ times in the Diamond thread so this is the final time I will answer:
IT MEANS NOTHING..NADA..ZIP! I have not experienced ANY problem with this output...Please stop asking!
-------------------------------------------------------------------------
As we all know MTTY is the key here, but I can say from personal experience that this small piece of software is a MASSIVE pain in the ass to get working, i must have tried 15-20 different “recommended” procedures to get it work and all failed.
But I managed to find a failsafe method of getting MTTY working on Vista AND Windows 7, also x86 AND x64!! (I have all 4 windows installations and the methods detailed below worked on all)
NOTE: WORKS WITHOUT DRIVER INSTALL ON XP
If for some reason you cannot got this to work on XP do the following: (Thanks kgerry!!)
Hi,
if you run XP and you have Problems to connect to USB try following:
1. Launch ActiveSync on PC
2. Go to connection settings
3. Uncheck the Allow USB Connection
4. bring the device to bootloader.
5. Now, run mtty ...
... try again to switch from COM1 to USB and follow the instructions of perfect post 3
Hope it helps ... Kgerry
Here is how this thread works:
Post 1: Description
Post 2: Driver Installation
Post 3: MTTY Instructions For FLASHING FROM INTERNAL STORAGE
Post 4: MTTY Instructions For FLASHING FROM YOU SYSTEM
THANKS to:
Reb0rn - for pointing me to the light!
l2tp - for the images
lunasea - for providing me with working drivers
and of course to anyone else I forgot.
I hope this helps people!!
MG
Donations:
stokedanuk
Thanks VERY muchly!!!
Last edited: