[SOLVED]Can't go into flash mode

Search This thread

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
I'm trying to flash a FTF in FlashTool but my Xperia Play(R800a) isn't going into Flash Mode it just shows "Sony Ericsson" and then it starts charging. I have installed the drivers and even Unlocked the Bootloader via the TP method.

Any help will be much appreciated.


Solution:
This is what I have to do to get into Flash Mode
(RED=What was done different, Green=What was done the same)

1.Open FlashTool
2.Select Flash Mode
3.Select Firmware (FTF)
4.Wait till FlashTool tells you to connect your phone in Flash Mode
5.Remove Battery from phone
6.Connect phone while holding Back Button(With no Battery)
7.Insert battery
8.FlashTool will start Flashing the FTF, once done Reboot and enjoy

In order for this TO WORK Steps 6 and 7 have to be done REALLY FAST
 
Last edited:

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
Nobody Can Help? :(

Okay, I was able to go into Flash Mode in PCC but I still wasn't able to do it in FlashTool. I was also able to Root my phone but that didn't help ether. I also noticed that when the phone starts Charging after I failed to go into Flash Mode it says that Debugging is Off, witch is wrong(I do have Debugging On). Its also says that Debugging is Off when I first open flash tool and then connect the phone but it does recognizance Debugging On if I first connect my phone and then open FlashTool. Is Debugging the problem???

I also want to add that I have a Xperia X8 and FlashTool work fine with it.

Any body out there that had or has a problem like me???
 

Bakisha

Senior Member
May 4, 2011
973
535
Try different usb cable or different usb port on PC.
Also, does your back button working when you boot into rom?
Maybe updating flashtool might help...

Don't be confused with that "debugging off" message, because you only need it when you are in normal mode. There is no point /need/purpose for debugging when phone is in flash, fastboot or charging mode (nor it is possible). Flashtool only report lack of it, but since you don't need it, just ignore it)


Sent from my C6502 using xda app-developers app
 
  • Like
Reactions: TheScriptKitty

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
Try different usb cable or different usb port on PC.
Also, does your back button working when you boot into rom?
Maybe updating flashtool might help...

Don't be confused with that "debugging off" message, because you only need it when you are in normal mode. There is no point /need/purpose for debugging when phone is in flash, fastboot or charging mode (nor it is possible). Flashtool only report lack of it, but since you don't need it, just ignore it)


Sent from my C6502 using xda app-developers app

I tried both a different Usb Cable and different Usb Port, I also tried it on a different PC. Yes the Back Button works when the ROM is already booted(and also worked when going into Flash Mode in PCC). I also have the latest version of Flash Tool. :(

Any other ideas to what might the problem be???
 

Bakisha

Senior Member
May 4, 2011
973
535
I tried both a different Usb Cable and different Usb Port, I also tried it on a different PC. Yes the Back Button works when the ROM is already booted(and also worked when going into Flash Mode in PCC). I also have the latest version of Flash Tool. :(

Any other ideas to what might the problem be???

Maybe PCC and Flashtool are in conflict. Exit PCC (right-click on systray icon). Also, kill all adb.exe processes from task manager before starting flashtool.

If that don't work, try more desparate measures: uninstall and install again drivers or PCC or flashtool...

Sent from my C6502 using xda app-developers app
 
  • Like
Reactions: TheScriptKitty

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
Maybe PCC and Flashtool are in conflict. Exit PCC (right-click on systray icon). Also, kill all adb.exe processes from task manager before starting flashtool.

If that don't work, try more desparate measures: uninstall and install again drivers or PCC or flashtool...

Sent from my C6502 using xda app-developers app

I tried doing that at the very beginning but didn't help :(

Do you know if there is an ADB Command to but into Flash Mode? Because I found one for Fastboot (adb reboot fastboot) but couldn't find any thing for Flash Mode.

Btw thanks for all the help.
 

Bakisha

Senior Member
May 4, 2011
973
535
I tried doing that at the very beginning but didn't help :(

Do you know if there is an ADB Command to but into Flash Mode? Because I found one for Fastboot (adb reboot fastboot) but couldn't find any thing for Flash Mode.

Btw thanks for all the help.

I don't know either If there is adb command for flash mode.
And i'm out of ideas why flash mode don't work.
Unless... You are pressing and holding back button before pluging usb cable, right? Sry, as i said, i am out of ideas...

Sent from my C6502 using xda app-developers app
 
  • Like
Reactions: TheScriptKitty

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
I don't know either If there is adb command for flash mode.
And i'm out of ideas why flash mode don't work.
Unless... You are pressing and holding back button before pluging usb cable, right? Sry, as i said, i am out of ideas...

Sent from my C6502 using xda app-developers app

I got it working! but only once in Flashtool. I don't think I did some thing different but some how it worked. I wasn't able to do it again :( any way one flash was all I needed. :)

Thanks for your help any ways
 

TheScriptKitty

Senior Member
Dec 11, 2013
360
806
Mexico City
Xiaomi Poco F3
Solution

Solution:
This is what I have to do to get into Flash Mode
(RED=What was done different, Green=What was done the same)

1.Open FlashTool
2.Select Flash Mode
3.Select Firmware (FTF)
4.Wait till FlashTool tells you to connect your phone in Flash Mode
5.Remove Battery from phone
6.Connect phone while holding Back Button(With no Battery)
7.Insert battery
8.FlashTool will start Flashing the FTF, once done Reboot and enjoy

In order for this TO WORK Steps 6 and 7 have to be done REALLY FAST
 
  • Like
Reactions: Bakisha

Bakisha

Senior Member
May 4, 2011
973
535
Strange, i must say. My guess was on faulty usb cable, but i'm glad you found a solution...

Good for future reference, for someone with similar problem
 

Top Liked Posts

  • There are no posts matching your filters.
  • 1
    Try different usb cable or different usb port on PC.
    Also, does your back button working when you boot into rom?
    Maybe updating flashtool might help...

    Don't be confused with that "debugging off" message, because you only need it when you are in normal mode. There is no point /need/purpose for debugging when phone is in flash, fastboot or charging mode (nor it is possible). Flashtool only report lack of it, but since you don't need it, just ignore it)


    Sent from my C6502 using xda app-developers app
    1
    I tried both a different Usb Cable and different Usb Port, I also tried it on a different PC. Yes the Back Button works when the ROM is already booted(and also worked when going into Flash Mode in PCC). I also have the latest version of Flash Tool. :(

    Any other ideas to what might the problem be???

    Maybe PCC and Flashtool are in conflict. Exit PCC (right-click on systray icon). Also, kill all adb.exe processes from task manager before starting flashtool.

    If that don't work, try more desparate measures: uninstall and install again drivers or PCC or flashtool...

    Sent from my C6502 using xda app-developers app
    1
    I tried doing that at the very beginning but didn't help :(

    Do you know if there is an ADB Command to but into Flash Mode? Because I found one for Fastboot (adb reboot fastboot) but couldn't find any thing for Flash Mode.

    Btw thanks for all the help.

    I don't know either If there is adb command for flash mode.
    And i'm out of ideas why flash mode don't work.
    Unless... You are pressing and holding back button before pluging usb cable, right? Sry, as i said, i am out of ideas...

    Sent from my C6502 using xda app-developers app
    1
    Solution

    Solution:
    This is what I have to do to get into Flash Mode
    (RED=What was done different, Green=What was done the same)

    1.Open FlashTool
    2.Select Flash Mode
    3.Select Firmware (FTF)
    4.Wait till FlashTool tells you to connect your phone in Flash Mode
    5.Remove Battery from phone
    6.Connect phone while holding Back Button(With no Battery)
    7.Insert battery
    8.FlashTool will start Flashing the FTF, once done Reboot and enjoy

    In order for this TO WORK Steps 6 and 7 have to be done REALLY FAST