Got my Skinomi skins today and after applying I have to say I'm impressed. I was eager to see if it would fit in the dock with it on too, and it does. It's just a little tight but it does fit fine.
When the skin arrives it comes shipped in a tube, since it's rolled up in the tube the ends of the skin want to peel up. If it was rolled the other way it would of been much better. After learning from the tablet skin I re-rolled the dock skin the other way and put it back in the tube for 30 minutes or so and that helped.
My advice when putting the skin on is to only use the application fluid on the large main skin parts (top for the tab and bottom for the dock), and be sure NOT to get any fluid on the small edging/side parts of the skin. Once the main back part is on, bubble free and aligned it will be easy to stick down the sides if there's no fluid on them. In my case I put the fluid all over and the smaller side parts kept peeling themselves up and it took a lot of holding down till they were stuck (the whole process took me about an hour for the tablet).
Lesson learned, on the dock skin I only used a small amount of fluid on the main bottom part and none on the little parts and it was a much faster process. Using a hair dryer will aide in the drying time and also makes the skin more malleable so it doesn't want to peel itself back.
The tablet skin comes with a clear screen protector that I'm not using. I use an anti-glare screen protector (3 pack available on Amazon for $14.95) and I like this set up a lot. A few other reviews for this skin said because the clear screen protector is a bit sticky when you close the tab the screen sticks to the skin on the dock and it cause bubbles in the screen. With the very non-sticky screen protector I have, this isn't an issue.
All-in-all I'm impressed with the skin. It's a very tough vinyl, has a great texture to it (actually feels like carbon fiber and makes for a nice feel in the hand) and provides good coverage on almost all of the tablet and dock.
The only down side is the set up (especially if you use a different screen protector) is a little pricy... But, if you want to protect your tablet and dock while making the setup look bad @ss this is the way to go!!
UPDATE: A small part of the corner of the skin (a very thin strip that covers the corner on the top of the tablet) came off, was torn by the case. I contacted Skinomi as the skin has a lifetime warranty and they're sending me a whole new skin for free. Prompt customer service too. Good company...
Links:
Tablet skin on Amazon, $26.94 with shipping
Dock skin on Amazon, $18.94 with shipping.
If you like this review please click the thanks button below!!!
If anyone wants pics of any specific part of the tab or dock to see exact fitting just let me know and I'll take it and post here!
When the skin arrives it comes shipped in a tube, since it's rolled up in the tube the ends of the skin want to peel up. If it was rolled the other way it would of been much better. After learning from the tablet skin I re-rolled the dock skin the other way and put it back in the tube for 30 minutes or so and that helped.
My advice when putting the skin on is to only use the application fluid on the large main skin parts (top for the tab and bottom for the dock), and be sure NOT to get any fluid on the small edging/side parts of the skin. Once the main back part is on, bubble free and aligned it will be easy to stick down the sides if there's no fluid on them. In my case I put the fluid all over and the smaller side parts kept peeling themselves up and it took a lot of holding down till they were stuck (the whole process took me about an hour for the tablet).
Lesson learned, on the dock skin I only used a small amount of fluid on the main bottom part and none on the little parts and it was a much faster process. Using a hair dryer will aide in the drying time and also makes the skin more malleable so it doesn't want to peel itself back.
The tablet skin comes with a clear screen protector that I'm not using. I use an anti-glare screen protector (3 pack available on Amazon for $14.95) and I like this set up a lot. A few other reviews for this skin said because the clear screen protector is a bit sticky when you close the tab the screen sticks to the skin on the dock and it cause bubbles in the screen. With the very non-sticky screen protector I have, this isn't an issue.
All-in-all I'm impressed with the skin. It's a very tough vinyl, has a great texture to it (actually feels like carbon fiber and makes for a nice feel in the hand) and provides good coverage on almost all of the tablet and dock.
The only down side is the set up (especially if you use a different screen protector) is a little pricy... But, if you want to protect your tablet and dock while making the setup look bad @ss this is the way to go!!
UPDATE: A small part of the corner of the skin (a very thin strip that covers the corner on the top of the tablet) came off, was torn by the case. I contacted Skinomi as the skin has a lifetime warranty and they're sending me a whole new skin for free. Prompt customer service too. Good company...
Links:
Tablet skin on Amazon, $26.94 with shipping
Dock skin on Amazon, $18.94 with shipping.
If you like this review please click the thanks button below!!!
If anyone wants pics of any specific part of the tab or dock to see exact fitting just let me know and I'll take it and post here!
Last edited: