Humm I had magldr 1.12 loaded on it and I believe before I even installed MAGLDR 1.12 that it needed HSPL 2.08. Do you think I need to install HSPL 2.08 once again before updating to MAGLDR 1.13? I already have the correct radio. So let me know what you think.
An error has occurred
Read below for more information
Error Description: Config load failed.
Info: .\RSPL\RSPL.cpp (725)
Error Description: CONFIG: can't open config file
Info: .\RSPL\RSPL.cpp (304)
Installation:
You need radio which support 576 RAM.
Run ROMUpdateUtility.exe and install it.
That's not a solution, that's just following the instructions.I can't figure where's the prob....it's shows me this error when i trying to install MAGLDR 1.13.
Code:An error has occurred Read below for more information Error Description: Config load failed. Info: .\RSPL\RSPL.cpp (725) Error Description: CONFIG: can't open config file Info: .\RSPL\RSPL.cpp (304)
Edit:
I found a solution!!!
Go to -->ROMUpdateUtility.exe
Right Click---> Run as administartor
Ignore DWI Just run ROMUpdateUtility.exe !!!
And the MAGLDR 1.13 will be installed on your device properly
Tested by me from 1 min. ago
Good Luck
Are you running the daf.exe file or as is clearly stated on the first page (and 2 posts up and probably on every second page since 1.13 was released) - you need to run romupdateutility.exeI also have the same error:
An error has occurred
Read below for more information
Error Description: Config load failed.
Info: .\RSPL\RSPL.cpp (725)
Error Description: CONFIG: can't open config file
Info: .\RSPL\RSPL.cpp (304)
But I tryed your solution and as I am using windows xp I cannot run as administrator
any ideas?
Seems like I am having problems with Usb mass storage. My computer will hang while transferring files to my sd card.
Sent from my HTC HD2 using XDA App
Easy, upgrading from 1.11/1.12 to 1.13 doesn't brake the actual ROM, so all you need to do is:
- power down the phone
- power up + keep vol down pressed -> goes to rainbow screen with HSPL
- connect usb cable
- run ROMUpdateUtility.exe from MAGLDR113_DAF package
- continue to the end
- reboot (you may need to do it twice) and voila, Android should still be there
Basically all of that is on page 1 as well
My 8 GB Kingston Class 4 MicroSD card does not seem to work in Magldr (1.13), is there anything I'm doing wrong?
I'm trying to boot an android build from SD card
This is what happens:
- I go into SERVICES in Magldr
- I go into BOOTSETTINGS
- I go into AD SD DIR
- At this point it just returns me to the start screen of Magldr. No error.
The card works fine in Android itself.
I've tried the following:
- Formatted the card with SDFormatter (FAT32)
- Formatted the card from within android (FAT32)
- Formatted the card from Windows (FAT32)
- Formatted the card from Linux (FAT32)
Any takers?
Why won't the bootloader screen change from serial to usb after I plug in my usb cord to my hd2? So frustrating
Is my pc supposed to have a certain driver installed for it to recognize my hd2 is connected to it via usb??
Any info helps, thanks