The Flashing Procedure for this Korean Galaxy A is similar to the Korean Galaxy S But this model has limited ROM's and Rooting Kernels as it was not that popular once the Galaxy S was revealed three months later.
You Can download an Instructions manual from Here
You need to use Odin3 version 1.32 (Attached below)
You need USB Drivers (Attached below)
ROMS Currently Available
Stock ROM DB19
Galaxy A 2.2.1
KyuHyuk 2.0.1 (Rom 2.2.1 Cooked)
MiRu ROM PE 2.5
GA ROM 1.5
How to Root?
You can use Framaroot app or Unlockroot from your PC or Cydia Impactor from PC
Flash Rooted ROM EG04
Download Mode : Press and hold vol up + vol down + Power button
Recovery Mode : Press volume up + power button
General advice prior to Flashing any phone
Its always best to do a "clean" install. meaning you should remove any old scripts, data, cache, junk before flashing a new ROM, this is like taking a bath before using new clothes. For some models it is a must do, for others it may not be a major problem or can be resolved by flashing the dbdata.rfs to clear out the remaining junk that you failed to remove before flashing . But if you had "lagfix" and did not undo it, it can cause internal SD card unavailable situation, which can be difficult to resolve.
Hence before flashing its advisable to
a) undo lagfix, IF you had any.
b) Do a factory reset by settings>Privacy> factory reset ( erase SD Card - optional , as formatting SD card could be too)
c) And even going into recovery to wipe everything is also good.
d) Removing SIM Card and External SD card ( makes it easier for phone to boot up initially after flashing a new ROM)
Doing this will give you a "Clean" install or fresh start for your phone.
Make sure your Battery Charge is more than 50%, Samsung requires you to have 100% charge when using KIES to upgrade.
1). You need to Factory Reset Phone first go to settings >Privacy> factory reset also can be done in recovery
2) Power Down and Enter Recovery Mode and wipe data and wipe cache
3) Power down and remove battery, Then reinsert the battery and Enter Download Mode
4) Fireup Odin3 ver 1.32 on PC and Connect phone with USB cable to PC
5) Now select the ROM you had downloaded in Odin under PDA ( do not tick or press anything else ) and DON'T Interrupt flashing unless stuck for some time
6) Press Start Button on Odin3 and wait till is completed
7) Once phone has booted up and everything is working, power down and enter Recovery Mode, here you "factory Reset" phone one more time
That's it Now you will be using the new ROM you just flashed.
You Must watch this documentary concerning your privacy Terms & Conditions we had agreed to, by using a PC or Smartphone
How to say Thank you? If you find any post helpful on XDA, please click on the Thanks button
If you are using XDA App or Tapatalk, long press on the post and select Thanks Its easier to give "Feedback" in this manner than make an additional post.