I would like to enlarge the data partition of my Samsung S2 I9100, and there is a good thread about it here.
It has the command to flash the PIT as
But heimdall is refusing to flash, I guess because I have to specify all partitions with the same command:
It's heimdall 1.4.0. Is it not possible anymore to flash just the PIT?
P.s.: Of course it is dangerous, I know, I diffed old and new PIT file and only the data and ums partitions seem to change.
It has the command to flash the PIT as
Code:
$ heimdall flash --repartition --pit newpit.pit
But heimdall is refusing to flash, I guess because I have to specify all partitions with the same command:
Code:
$ heimdall flash --repartition --pit I9100_16GB_6GBdata.pit
Action: flash
Arguments:
--repartition --pit <filename>
--<partition name>|--<partition identifier> <filename> [...]
[--verbose] [--no-reboot] [--stdout-errors] [--delay <ms>]
[--usb-log-level <none/error/warning/debug>]
or:
--<partition name>|--<partition identifier> <filename> [...]
[--pit <filename>]
[--verbose] [--no-reboot] [--stdout-errors] [--delay <ms>]
[--usb-log-level <none/error/warning/debug>]
Description: Flashes one or more firmware files to your phone. Partition names
(or identifiers) can be obtained by executing the print-pit action.
WARNING: If you're repartitioning it's strongly recommended you specify
all files at your disposal.
It's heimdall 1.4.0. Is it not possible anymore to flash just the PIT?
P.s.: Of course it is dangerous, I know, I diffed old and new PIT file and only the data and ums partitions seem to change.